PDA

View Full Version : SR20 won't start! Halp!


guitardave06
11-11-2016, 10:15 PM
So I just bought an S13 with an SR. It was running fine and made the 140 roundtrip drive to work for almost a week, just fine. Well after getting back into town yesterday, it was running fine when I pulled into the car wash. After I washed it (self serve car wash), I started it and it began to run on only or 2 cylinders. I figured something just got wet so I turned it off and popped the hood to try and figure it out. I did everything I could with the resources that I had, then called one of my buddies because I couldn't figure it out. He messed with it a bit trying to figure out what was wrong by process of elimination. We eventually got it towed to a busy of our as shop. We liked at it tonight and tried/did a few different things. Switching out the ecu, changing spark plugs, checking the CAS, checking spark, regrounding the battery and motor, checked for fuel delivery, checked the ignitor/ignition but still no luck.


We are short of at a loss. Any help would be greatly appreciated guys!

Kingtal0n
11-12-2016, 12:51 AM
what were the results of the spark test? Do all cylinders spark?

Do a compression test,
check the fuel pressure,
check for spark on all cylinders,

spark/fuel/air should cover it

guitardave06
11-12-2016, 04:39 AM
Spark is good, as well as the fuel pressure. Haven't done a compression test yet, but we will probably check that when I get off of work. Would bad compression on one or more cylinders cause it not to start? When I blew rings on my KA-T it started but smoked really bad.

cotbu
11-12-2016, 09:50 AM
Bad compression in one cylinder will not cause the engine to not start it would have to be all cylinders or zero compression.
Sure there's probably a combo but either way you still wont start.

Spark, Timing, air, fuel and compression.

Sent from my LG-H631 using Tapatalk

Dboyizmlg
11-12-2016, 10:53 AM
^^^ exactly what Mr. Cotbu has mentioned