sr20 revs slow

[c-los13]

ive noticed that compare to other sr's mine doesnt rev up as fast,
almost like the flywheel is too tight
its a blacktop, t25, fmic godspeed , hks bov, spec 2 clutch
the car runs and boosts fine, it just climbs through the rpms too slow
anybody have any ideas what could be causing this problem?
could it the something w the flywheel???

[JDMRIDDAZ]

vac leak
tps mal adjusted
cas is retarted..lol

[c-los13]

vac leak where??? i know my way around ka but im kidan new w sr's, i dont see alot of vacuums though
how can i check if the tps is misplaced??? i did take off my intake manifold when i got the motor because it had calcium buildup
how can i check the timing??? idk if the motors been opened before so idk, it looks pretty stock
im running the car at 10lbs and still feels pretty stock =( helllpppp

[OkiDori17]

id def. check for a boost leak
as for the tps, its located on the right side of the throttle body, it should have a red connector, but check it for bent pins i knew a buddy who bent one whop had kinda the same problem

[army240]

You should do a compression test to make sure your engine is still in good shape.

And there is nothing wrong with your flywheel...

Frank

[c-los13]

after lookiing at the engine bay for 20 minutes and making sure everythign was bolted on right i found that the o2 sensor wasnt crewed all the way in =/
that made a lil differences, then a friend came by and we realized and i would give it full throttle the throttle body wouldnt open all the way so we fixed that =)
ima check for a boost leak tomorrow at a this guys shop
thanks for the replies
im kinda new to sr's, be patient ill catch up pretty fast =)