Power fc boost kit question???

[1997silvia]

i have a s13 sr with gt28rs turbo 550's, pfc d-jetro, and some other things, but i recently got it running pretty good and had to put a new wastegate on it because the old one was leaking, did that and all it wants to run is 10psi just off the wastegate no matter what setting in my commander i have it on just 10 psi, pretty sure its wired correctly into the ecu and i have the vac lines correct too. i have tried all kinds of boost settings but no change
any help greatly appreciated!

[xska]

With ignition on engine off, blow air in your apex map sensor (with your mouth not 100psi from air hose), solenoid should clicks loud.
if not, check the wire for power.
It should have 12v to one and blinking ground on other with pressure in map sensor.

[1997silvia]

i will try this today, so blow in the map and the boost solenoid will click or that map clicks?

[xska]

Boost controller solenoid clicks.
It should be connected to your waste gate.

[1997silvia]

ok gotcha ill try that right now

[Sileighty_85]

did you turn on the Boost controller using the commander?

[1997silvia]

ya i tried it both ways just to make sure but i believe that a smiley face means that it is off.





did you turn on the Boost controller using the commander?

[1997silvia]

ok so i blew air into my map with ignition on and engine off and nothing happened at all? does this mean we have a wired off the boost solenoid wrong?
any other suggestions?
thanks guys

[xska]

So now, check for power and blinking ground.
It should have power with ignition on.
And if you don't have power on this one, your O2 heater is not getting power also.
It's common harness problem. someone didn't wire it right.

[1997silvia]

i will check that thank you much