KA24e to SR20de swap

[xHellaFlushS13x]

I'm doing a swap to a SR20de in my 90 240 and I'm looking for help. Engine is in the car. Need wiring advice. Also what hoses to get. Basically anything you think would help. Thanks.

[freeagent3117]

I'm doing a swap to a SR20de in my 90 240 and I'm looking for help. Engine is in the car. Need wiring advice. Also what hoses to get. Basically anything you think would help. Thanks.

This is what I used for the engine harness.

SR20DET Swap Engine Harness Wiring Diagram Guide SR SR20 (http://www.frsport.com/SR20DET-Swap-Engine-Harness-Wiring-Diagram-Guide-SR-SR20_t_26.html)

The lower harness is the same, just dont need two plugs off tranny(only use speed sensor)

Heres the vacuum lines

S13 Vacuum Diagram : SR20DET Forum (rear-drive) (http://forums.nicoclub.com/s13-vacuum-diagram-t305170.html)

Not sure what else you need.....

[Pro ViZIon]

Are you putting an n/a sr or a turbo one? There's info everywhere.

[zombiewolf513]

and you need the KA water temp sensor installed on the SR if you want to maintain your temp gauge.

Go wiring specialties, chyea

[xHellaFlushS13x]

It's an S15 SR20 NA. And so far I've handled everything. The wiring is a whore but hopefully it goes well. We're using the SR harness with a few KA plugs. Zombie is that Your RPS in the picture?

[zombiewolf513]

Nah, my RPS is in my build thread \/ down there.

I just did an S15 SR swap on her too!

[wiring specialties]

and you need the KA water temp sensor installed on the SR if you want to maintain your temp gauge.

Go wiring specialties, chyea

OP, We can help if you are interested.

[h2v7]

need a dohc cluster too right

[zombiewolf513]

Would he?

msglength