Will a TH400 fit into a S13

[JollyRoger]

I am doing the v8 swap and building a mild LS1 engine. I would like to use this trans but i need to make sure it will fit. I don't mind doing a alittle "messaging".... I've searched btw and nothing....


Thanks

[theboy]

you be doing a lot of massaging. For shits and giggles when i was swapping my sohc to a dohc-t i through a dummie 350 block camaro bell housing with th400 in it to see if it would work. also tried a th350, corvette 4 speed and a rock crusher

and all im going to say is that youve got a lot of work ahead of you. with fab you can fit anything into an s-chassis

if you go for it please take lots of pictures and document everything. Im curious how you end up doing it

[JollyRoger]

Bring this back from the dead as im thinking about switch trans if i have too....

[mxsx25]

If nobody has input on this... than that's even more reason to go for it and make it happen and like stated above... pics and document everything!!! Experimentation means progression!

[JollyRoger]

I just don't think it'll fit..

[Flicktitty]

i talked to nismoknights on here about this a while ago, and he was running a TH350 and he said it "fit" i've seen a few other 2JZ/TH400/TH350 guy's running them so it shouldnt be much of an issue.

i would say its nothing a hammer couldn't take care of.

[JollyRoger]

Anyone else...

[91SXHatch]

i have built hundreds of th400s they are full hydraulic tho.will the bellhousing work? if not try advance adapters, i would go with a th350 tho bc of the weight. both re creap to rebuld and very simple just get a haynes tech book. and to make it work fab up a x member and buy a ratchet shifter they are cable actuated. andon the plus side the trannys are everywhere and can be found for cheap