PDA

View Full Version : fender rolling/pulling question


Speedstyles408
01-17-2010, 09:53 AM
hey i'm a newb at this i got a s13 hatch and i'm tryin to fit 17x9 +0 wheels curious how much of a roll or pull i would need and how much negative camber i would also need thanks for any help

davirene
01-17-2010, 10:20 AM
Your tires and your stance are what you should consider....Dont roll until you have the tires and the look you want. I have 18x9.5 with a stretched tire. I have about a 3 inch drop all around. I also have a 14mm spacer on the front with a custom made 31mm spacer on the back.
http://i2.photobucket.com/albums/y14/davirene/1011091617.jpg

This pic was right before I put the spacers on the rear and before I lowered it.
http://i2.photobucket.com/albums/y14/davirene/100_5879.jpg

http://i2.photobucket.com/albums/y14/davirene/1112091547.jpg

Speedstyles408
01-17-2010, 12:40 PM
well i'm basically trying to tuck tire on the rears and the fronts i'm tryin to run a 215-45 if i wanna run a 215-40 . thats the stance i'm lookin for

HPballer76
01-17-2010, 12:45 PM
just put on your wheels and tires and roll/pull till you have the stance you want..

Maiku240sxS14
01-18-2010, 08:23 AM
To roll or pull your fenders is BECAUSE you are rubbing somewhere. If your not rubbing, no need to roll or pull your fenders.

So how about you put your wheel/tires on, drive around and check to see if your rubbing. Then roll/pull what is necessary.