nissan240
03-06-2009, 02:59 AM
long story short piston ring went on me one night i was coming from work!
i got it rebuilt(will list mods on bottom) from a pretty reputably guy. dont want to start bashing him or his shop so keep at that for now! got my car back from the shop installed it and now its blowing black bluish smoke! my turbo was good when the rings went out! now my question is, is my motor still good? or my turbo from sitting a bizzlion years? did oil(20w50) get into my rings already after just firing it up for about ten min? havent taken turbo off to see if theres any oil on turbo yet! did a compression test but was low! what i remember if a motor is freshly rebuilt or built it should have all low compression unitl all the ring seats! also it only blows smoke at idle, whenever i keep it at a steady rev at about 3g smokes goes away! havent driven it out of driveway yet!
as for mods here it goes
head:
3angle valve job(portmatch)
bc valves srings and retainers
tomei 256 by 256 camshafts
freddy mani
arp head studs
ngk iridium plugs heat range 8(didnt re-gap, it was already pre-gapped)
greddy rocker arm stopper
cosworth head gasket 1.2mm
oem intake and exhaust valve stem
hks gt-rs turbo
block:
eagle h-beam rods
cp 86.5mm pistons
oem main seals
acl rod main bearing
edged and knifed crank fully balanced
oem water/oil pump
oem timing chain
hot tanked
oem gasket set
any suggestions would help!!! thanks
i got it rebuilt(will list mods on bottom) from a pretty reputably guy. dont want to start bashing him or his shop so keep at that for now! got my car back from the shop installed it and now its blowing black bluish smoke! my turbo was good when the rings went out! now my question is, is my motor still good? or my turbo from sitting a bizzlion years? did oil(20w50) get into my rings already after just firing it up for about ten min? havent taken turbo off to see if theres any oil on turbo yet! did a compression test but was low! what i remember if a motor is freshly rebuilt or built it should have all low compression unitl all the ring seats! also it only blows smoke at idle, whenever i keep it at a steady rev at about 3g smokes goes away! havent driven it out of driveway yet!
as for mods here it goes
head:
3angle valve job(portmatch)
bc valves srings and retainers
tomei 256 by 256 camshafts
freddy mani
arp head studs
ngk iridium plugs heat range 8(didnt re-gap, it was already pre-gapped)
greddy rocker arm stopper
cosworth head gasket 1.2mm
oem intake and exhaust valve stem
hks gt-rs turbo
block:
eagle h-beam rods
cp 86.5mm pistons
oem main seals
acl rod main bearing
edged and knifed crank fully balanced
oem water/oil pump
oem timing chain
hot tanked
oem gasket set
any suggestions would help!!! thanks