View Full Version : Help! Sr Ecu Code 55 My Only Car
s13dan
05-01-2005, 07:27 PM
Ok i made another post about my car misfiring, its wierd but anyway my car threw an ecu code 55which i read was consult terminal reqiured i dunno what that means. can anyone PLZ help me i have a job and school i need to get to plz help if you know anything or even have an idea..
Flybert
05-01-2005, 07:49 PM
Do you have a wife and kids too? AHAHAHA. Code 55 means all your sensors are working fine. Try searching next time.
s13dan
05-02-2005, 11:10 AM
my car is still not able to move its self and its an SR and i read that code 55 mean other malfuction consult terminal reqiured.. is that a nissan scan tool or somthing?
Flybert
05-02-2005, 01:16 PM
If your car is misfiring, the first thing you should be checking is your ignition timing and spark plug condition and gap.
s13dan
05-02-2005, 01:57 PM
Spark plugs were tatally fouled but that was because of what ever is causing my car to mess up because a week ago they were very good, and at idle im getting spark to all plugs.. and timing wouldnt just mess up while driving would it?
Flybert
05-02-2005, 03:32 PM
Check your timing. Go buy a cheap inductive timing light from sears or autozone or whatever. Make sure it's a cheap one that doesn't have any special features because the expensive ones like to read 10 degrees off on SR's. Warm up your car for about 5 minutes until it gets to operating temp. Turn the car off, unplug the TPS, turn it back on, race the engine a couple times, and check the timing with the timing light. Make sure it's set to 15 BTDC which is the second mark from the right.
If the timing is dead on, then you need to start checking your different sensors such as your MAFS, TPS, knock, ECT (engine coolant temperature) sensor. O2 sensor doesn't really need to be checked because it only operates when you are cruising with a steady constant throttle. Read the S14 SR FSM for specs on all the sensors. The only S13 sensor that has different voltage or resistance specs from the S14 is the MAFS.
SRfairladyZ
06-26-2005, 09:16 PM
I cant get a reading on my light with my S14 SR, what do you hook the signal clamp onto with these coil packs? Thanks.
sr240mike
06-26-2005, 09:21 PM
Pull back the plastic a bit on the wiring to the #1 coilpack. You may have to play with it a bit in order for the light to pick up a signal.
SRfairladyZ
06-26-2005, 09:29 PM
Thanks guy, i'll play with it. ....The wire i mean. :)
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.