Crank Angle Sensor Confusion

[apex128]

Hello everyone,

I have an s13 transmission on my s14. There is no place for me to put a crank position sensor on the bellhousing. I know that this sensor is not needed for engine operation and am trying to get rid of the trouble code. How do I bypass the sensor? Can I use a resistor? Also, I deleted my egr and want to get rid of that code too. Can I use a resistor for that?

Thanks,
Evan

[apex128]

Bump. I need help on this guys.

[s13silvia123]

Measure, drill and tap hole to make it work on the bell housing. but that's me and i would of done it when i have the tranny out.

[apex128]

I would have done it when the tranny was out too. The issue is that I bought the car swapped. I just want to make sure there is no other way before I go about pulling the motor out / dropping the transmission. Do you know if the signal from the sensor is constant or does it vary with rpm? Also do you think that this code would fail emissions?

[apex128]

Bump. What ohm resistor could i use to bypass this thing?

[Agamemnon]

Bump. What ohm resistor could i use to bypass this thing?

You don't. Pull the trans out and follow this guide and do it right.
http://forums.nicoclub.com/s13-ka24de-transmission-conversion-for-the-obdii-s14-write-up-t384931.html