compression test, now no spark. kade

[soryu]

s13,kade,obd1.
i unplugged fuel pump fuse, spark plug wire from ignitor and plugs.
all 4made it to 150.
put fuse back in connected wires, no start checked for spark at plugs no spark.
tested ignitor and coil per FSM both in spec
checked for batt voltage at coil, yes batt voltage.
im going to check the wiring but is there anything that else that i should check
that is not in the fsm?
how do you pop off the ignition resistor?
fuel pump is working, rpm gauge moves a little when cranking.
car was running fine before test. avg 22mpg's
now getting code 21. i did swap out coil for new one still no start.

[soryu]

So I got spark now.
Still no start and rpm gauge not moving now.
Got codes 11, 21.
I tested crankshaft pos sensor(EF-EC159) voltage did fluctuate on pin 2 . It did not on pin 1
So is my dizz gone?
where are terminals A, B?

[soryu]

Anyone know more about this test?

[codyace]

Reset ECU and see what re appears

[soryu]

55 then Same code after I try to start the car up.

[codyace]

Check the plug end then to make sure you didn't pinch a wire or seperate it in the plug then.

[soryu]

Cps plug looks to be in good condition. Not separated or pinched.

[soryu]

uggghhh.
it was a tooth off i think.
i placed rotor before cyl1, rotor pointing left.
it started right up.
thanks for the input ace.