sleepyS14se
03-10-2014, 03:07 PM
Just curious what you guys do about the bottom mounting insulator when using a walbro FP.
I purchased and installed a GSS341 and i did my research just to confirm my pump was legit and not a fake. Anyway that is all well and good, my pump is legit.
One problem i ran into was the bottom insulator rubber piece does not fit the walbro very well and I ended up cutting a small section of it out and made it fit the best I could but I am not happy with it. Is there a certain insulator that is supposed to be used or are we stuck using the stock one and modifying it.
Notes:
95 s14
gss341 walbro 255
97 01 prelude sock
I purchased and installed a GSS341 and i did my research just to confirm my pump was legit and not a fake. Anyway that is all well and good, my pump is legit.
One problem i ran into was the bottom insulator rubber piece does not fit the walbro very well and I ended up cutting a small section of it out and made it fit the best I could but I am not happy with it. Is there a certain insulator that is supposed to be used or are we stuck using the stock one and modifying it.
Notes:
95 s14
gss341 walbro 255
97 01 prelude sock