S14 sr20det cold starting problem

[240psi]

Okay so before i swapped my s14 sr20 into my auto 95 zenki she used to start up right away. After i swapped it into my zenki i need to give it gas to turn over.
After The car has been started and driven she then starts right up with no problems. Can anyone tell me what to check? so i can start my car in peace every morning.

[Dboyizmlg]

Check you're wiring when you did the swap.

The issue might be on wiring from underneath the dash. Gauge cluster wiring.

Check those out real good, a few months ago I read that on a thread.

I also had the same issue, but my problem was with the small brown plug at the end of the harness. I had a few pins that corroded and snapped off.

[Dboyizmlg]

I think there is a cold start wire for the connector that goes under the dash, look at that first.

[240psi]

I also forgot to mention i put on some 350z wheels with some meaty tires and didn't realize it was hitting the fuze box harness every time i hit a bump. The car ended up popping the ignition fuze and leaving a mess of wires under my driver side fender. I just put the harness wires back together and added some wire too the ones that got ripped up pretty bad. Would this have anything to do with it?

[240psi]

Okay will check that

[steve shadows]

I would replace the water temp sensor as a start.