brake light stayed on, HELP!!

[Gamma]

Whats good guys my brake light stayed on even though my hand break is down what do u guys think it can be

[blksylv]

the little rubber grommet on your brake pedal probably came apart.

[stylo1]

yup, put a bolt and nut in there, that shit wont fall out

[Gamma]

sounds good ima check that shit out, good lookin guys much appreciated

[lalo167]

Check your brake fluid. There's a little sensor on the reservoir, if your fluid is low the light will stay on.
Sounds dumb but my brother just had this problem, we put brake fluid in and problem fixed!

[Slippin'eight-nine]

Check your brake fluid. There's a little sensor on the reservoir, if your fluid is low the light will stay on.
Sounds dumb but my brother just had this problem, we put brake fluid in and problem fixed!

^^^ this.. Mine would flick on when I would start cornering hard..

[Gamma]

rubber grommet on brake pedal is still there and brake fluid is good, any other suggestions cause that little light piss me off lol

[fliprayzin240sx]

Well, when you say brake light is on, are you talking about the brake light on the dash or your brake lights in the tail lights staying on?

[1990 sr hatch]

^good point if its your tail lights check the switch under the pedal on my old pos eclipse it had broke so i superglued some pennies back there so the switch had something to hit lol

[MrSanchez925]

Hes talking about the one on the dash.

It can only be 3 things.

Low brake fluid
E brake ground
or pressure differential valve is done for. (highly doubt this one)

[Gamma]

Sorry about tht guys should have explained myself and its the dash,, So gotta check if my ebrake is still grounded, or my pressure differ. valve is gone huh, lol better hope its my grounded ebrake... Any other suggestions are welcomed

[fliprayzin240sx]

Or the brake fluid reservoir sensor is fritzing. Sometimes floater will get stuck, knock the reservoir and see if the floater is stuck. As far as the e-brake, the wire could also be grounding out somewhere, not necessarily at the bottom of the handle.

When the handle is down, it pushes on a this switch and basically breaks the connection. When its up, the switch is on and the connection is grounded. That wire could be broke and grounding out somewhere between the handle and cluster.

[Gamma]

Appreciate the knowledge fliprayzin240sx

[MrSanchez925]

Easy way to tell if its the ebrake or the bmc is to pull the plug at the bmc.

If the light stays on then its your ebrake .
If it turns off then its the bmc.

[Kingtal0n]

Easy way to tell if its the ebrake or the bmc is to pull the plug at the bmc.

If the light stays on then its your ebrake .
If it turns off then its the bmc.

http://i23.photobucket.com/albums/b378/draglarry/zilvia1.jpg