S13 Sr Swap Problem...Wont turn off

[1slicktwo4oh]

Was up zilvians,
I swapped in an sr into my 92' s13 i turn it on, turns on fine everythings good mechanical wise. When i turn the ign. switch to the off position and take the key out, the engine stays on. Also the dash clocks brightness fluctuates, so im thinking i have a wiring issue but I dont know where to start checking??...CAN NAYONE HLEP!!!....

[[email protected]]

All you gotta do is re-pin the harness that goes over by the headlights on the passenger side. Just match colors. You're welcome.

[1slicktwo4oh]

i checked my wiring on the front harness and all the connection were right....it turned out that i had an inproper ground on my greddy t.timer. It turns off now, but the brightness of my clusters clock still fluctuates....can anybody help w/ my problem??????

[OkiDori17]

check all your grounds, you might have one loose somewhere else

[1slicktwo4oh]

Thanks ....ill check them all, hope it goes away...