Advice on Rb20 - SAFC - Z32

[RB25240]

Recently ran the vehicle with a SAFC and Z32 MAF, I removed both and wired the rb20 maf exactly how it was before, White wire to white wire, black to black, black white stripe to black white stripe, and black spot to black spot.

Now, the vehicle starts, but will only rev to around 3kish, It did this when I didn't have the SAFC installed with the z32, Do I have to reset my ECU or something to help it go back to stock?

The vehicle had a dead battery for a while, just trying to figure this out to sell the vehicle.


Everything is stock, and i'm not venting to atmosphere

[Pandapants]

If it's throwing a code, then yes, you have to reset the ecu; just disconnect the negative battery terminal.

If that doesn't work, make sure the wires are soldiered correctly and have continuity.

[RB25240]

Nevermind I fixed it!

I had a bad connection on the signal wire, Thanks to my meter I got it working.

Thanks!