Rb25 died after tuning

[Sideways_blksr20]

Problem solvedddddddddddddddddddddddddd

[r32skylinetn]

Your safc may of went bad, try unplugging it to see if that makes a difference. Your pump is priming but is your fuel filter clogged?(check for wet plugs also.) check all your intercooler couplers as well. Unfortunately rb engines are a pain so I'd check the ignitor and cas to be sure.

[Sideways_blksr20]

Im pretty sure fuel its gettin to the fuel rail cause i removed the hose that comes from the fuel filter to fuel rail and was shooting fuel when i turn key to on position.
Also theres a weird
Noise on the egi relay when i try to start the car

[Sideways_blksr20]

Btw i put somegason the air filter and the car starts for few seconds

[Sileighty_85]

well if your getting only 1v on the fuel injectors, then you need trace that system to find out why

[Sideways_blksr20]

But what about the egi relay is it suppose to make that noise

[Sileighty_85]

Sounds like bad wiring, id pull the harness and inspect it.

[Sideways_blksr20]

Yeah thats what my friend told me to fo . Im gonna do it in a minutr .thanks

[Sideways_blksr20]

Harness looks ok . Any ideas what else it might be ?

[mewantkouki]

Blowing the dipstick out = blow by...

[Sideways_blksr20]

Anyone else ?
I swapped ecu
Checked spark
Inspect harness
And still cant figure it out

[Sideways_blksr20]

I. Need help guyss

[ILoveJDM]

check the safc harness to make sure the maf signal in/out connection isnt loose

[Sideways_blksr20]

K thanks ill check it tomorrow

[Sideways_blksr20]

Your safc may of went bad, try unplugging it to see if that makes a difference. Your pump is priming but is your fuel filter clogged?(check for wet plugs also.) check all your intercooler couplers as well. Unfortunately rb engines are a pain so I'd check the ignitor and cas to be sure.

I tried disconnecting the safc and still wont turn on

[Sileighty_85]

you cant just disconnect it, you have to wire it back to stock as well as installing the stock Fuel Inj and MAFS

[Sideways_blksr20]

Problem solved. One of the wires from the chassis harness wasnt getting 12v