KenSR20
06-16-2011, 02:57 AM
I have a SARD fuel rail setup with top feed injectors on my sr20det. I am in the middle of installing an aftermarket intake manifold. When I took off my injectors off the old manifold I noticed one of my o-rings was damaged. It is from the metal circle piece that goes on the end of the injector and goes over the intake manifold.
Here is a picture:
http://www.socalevo.net/gallery/albums/userpics/10753/normal_Fuel%20Rail.JPG
What I need is an o-ring that goes around the small metal circle in this picture (there are 4 metal circle pieces that have o-rings on the outside of them) Any idea on how to get a size? I've emailed SARD and their phone number is disconnected. I've been to just about every parts place possible looking already. They bust out their o-ring kits and they are always too thick. I found one at a hardware store but I think it isn't for gas.
Thanks!
Here is a picture:
http://www.socalevo.net/gallery/albums/userpics/10753/normal_Fuel%20Rail.JPG
What I need is an o-ring that goes around the small metal circle in this picture (there are 4 metal circle pieces that have o-rings on the outside of them) Any idea on how to get a size? I've emailed SARD and their phone number is disconnected. I've been to just about every parts place possible looking already. They bust out their o-ring kits and they are always too thick. I found one at a hardware store but I think it isn't for gas.
Thanks!