RB26 S14 Clutch Fan

[FinkenS14]

Hey guys i got the clutch fan to fit on my s14 with my rb26 by notching my radiator support. I am running an oversized aluminum radiator,water, and watter wetter. Should i be ok cooling wise?

Also if i put a k's temp sensor in the rb will my stock gauge read more accurately?

[GSXRJJordan]

Take a pic of your setup, I'm guessing the shroud didn't fit and without that, you're suckin'.

[Sileighty_85]

you should look through my build thread and check out my cooling setup.

[FinkenS14]

Take a pic of your setup, I'm guessing the shroud didn't fit and without that, you're suckin'.

U don't think itwill work at all w/o a shroud?

[codyace]

U don't think itwill work at all w/o a shroud?

Nope, that shroud is crucial for it to work properly

[FinkenS14]

Hmmm i wonder if i cud make an sr or k's one work or make some. Got a set of two ten inch fans too i can wire in.

[codyace]

Hmmm i wonder if i cud make an sr or k's one work or make some. Got a set of two ten inch fans too i can wire in.

problem is how close RB is to the engine


why not go E-Fan?