PDA

View Full Version : Oil pan gasket


Smkns13
02-16-2011, 01:10 PM
hows it goin. I need to change my oil Pan gasket on my sr20. I'd like to buy one but, I've done some research and I'm lead to believe that there isn't a oil pan gasket for sale for the sr20. So what kind of sealant should I use for this. Thanks in advance

Korea
03-16-2011, 05:03 AM
you can just go to your local parts shop and look for a high temp liquid gasket, permatex has one. just make sure you apply it right and let it set. you dont wanna go blowing your engine cause your pan wasnt sealed right.

SocalCirca
03-16-2011, 05:26 AM
Go to Kragen or Autozone and ask them for the part. At Autozne the part # is:
#OS30646C

It should bolt right up. Make sure you buy PERMATEX RED HIGH TEMP sealant.

az_240
03-16-2011, 06:04 AM
That permatex stuff isn't as good as others out there especially for an oil pan. Search around I remember someone saying there was some OEM style sealant that works much better.

Sileighty_85
03-16-2011, 08:38 AM
That permatex stuff isn't as good as others out there especially for an oil pan. Search around I remember someone saying there was some OEM style sealant that works much better.

Ive used black permatex on all the SR and KA Oil pans Ive worked on and Never had one leak.

Usually the problem is ppl using High Temp RTV on the pans.

Yes the engine gets hot but not hot enough to need High Temp, Black RTV will be fine.

PoorMans180SX
03-16-2011, 08:51 AM
Did you search at all? This has been covered five million times.

Black RTV. Done.

obsolete
03-16-2011, 10:33 AM
always the black, never the red

jacobs13
03-16-2011, 12:47 PM
Oem sealant I heard doesnt dry, get the black rtv

Smkns13
03-17-2011, 07:26 AM
Thanks everyone. Im gonna put in some work this weekend doin that, a radiator and a diff. Thanks for the info
One

Pro ViZIon
03-18-2011, 04:42 AM
Have fun. The oil pan is a bitch haha.

Sileighty_85
03-18-2011, 08:11 AM
Its not that bad, I just did one yesterday on the ground, way better if you got a Lift though.

Pro ViZIon
03-18-2011, 11:29 AM
Yeah that's what I had to do. And jack up the engine from the tranny bell housing. My nismo power brace got in the way of removing the pan.

To op you should also unbolt the sway bar where it mounts to the frame. 2 14mm bolts each side.

95_S14
03-18-2011, 05:26 PM
Oem sealant I heard doesnt dry, get the black rtv

If you clean the block and the pan it's the best stuff out there I don't use anythin but oem it's not cheap but you get what you pay for it's 15 for thu tube and it will cover your pan water pump and thermostat housing