PDA

View Full Version : Suspension: S14 Front Spindle wont fit into S13 Ball joint?


Nismobound
01-12-2011, 02:14 AM
Hello fellow Techs,

I just installed S14 Front Spindles and they're not sitting in the A Arm ball joint very well. It seems that the ball joint on a S13 is bigger than the S14 ball joint hole. It isn't sitting very flush with the bottom of the A arm or even near it. Also the nut on the top of the ball joint thread doesn't clear the cotter pin hole. It's hard to get a angle to push the spindle down far enough, I just got a ball joint puller today i could use it to also press the spindle further down the ball joint. Any ideas??

LMK. Thanks!

iLagX
01-12-2011, 02:39 AM
impact gun!! power tools will fix it. haha. but your suppose to be running s14 control arm or s14 ball joint on s13.

az_240
01-12-2011, 02:58 AM
S13 and S14 front ball joints are DIFFERENT. Do NOT try using this combo. You will most likely break something which would be bad news if you are cruising.

S13 = S13

S14 = S14

Do not try mixing them

mad-ass
01-12-2011, 04:56 AM
since S14 LCA's are harder to find, here's easier solution.

buy new ball joints for S14, Moog part number K9820
find a J30 Front LCA.

problem solved.

Steve Lloyd
01-12-2011, 06:40 AM
Is the J30 LCA as long as the S14 control arm?? I know the S13 arm is shorted than the S14.

mad-ass
01-12-2011, 06:54 AM
J30 and S14 LCA's are same length. and identical location/diameter holes for the ball joint and tension rods.

Pandapants
01-12-2011, 09:58 AM
J30 and S14 LCA's are same length. and identical location/diameter holes for the ball joint and tension rods.

nice!

yeah, like az_240 said, you use the same balljoints as the spindle.

Nismobound
01-12-2011, 11:56 AM
Ok Thanks everyone! i think i might just go Moog ball joints.

1slowM6
01-12-2011, 02:27 PM
If you get j30 lca are the balljoints the same as s14?

Nismobound
01-14-2011, 07:12 PM
Will the S14 ball joint fit into the S13 LCA hole?

az_240
01-15-2011, 02:28 AM
S13 Front
Taper low diameter 15.8mm
Taper High diameter 18mm
Taper length 19.5mm
Diameter where it presses in 41mm

S13 Rear, R32 Rear
Taper low diameter 15mm
Taper High diameter 18.6mm
Taper length 23mm
Diameter where it presses in 38mm

R32 Front. S14 F&R , S15 F&R
Taper low diameter 15mm
Taper High diameter 18.6mm
Taper length 23mm
Diameter where it presses in 41mm

^Here is the info you need.

olah.inc
03-10-2011, 07:48 AM
So the s14 balljoint fits in the s13 lca hole?

Sileighty_85
03-10-2011, 08:06 AM
So the s14 balljoint fits in the s13 lca hole?

Yes.
msglght