Vg30e 350+wtq clutch options on the cheap.

[NoPistons!]

I'm doing a very budgeted medium hp build. Got my vg sitting on a pallet and two ka gearboxes along with a turbo ecu and harness and i'm looking at what to use to put all the power i wanna make to use. (nistune/holset/rx7 550cc injectors)

zingaling:

http://sphotos.ak.fbcdn.net/hphotos-ak-ash2/hs591.ash2/154302_177581092267712_100000474670873_606678_7102 897_n.jpg

http://sphotos.ak.fbcdn.net/hphotos-ak-ash2/hs591.ash2/154302_177581102267711_100000474670873_606681_6907 669_n.jpg


Now, the act six puck sprung disk is $84.00 shipped.

I have no idea if the stock pp is good enough or if i could switch to a 350z pp and swap out to a 250mm flywheel.

Just looking for options. I wanna hold power while keeping the car very streetable.

"pay money and get a full clutch kit and pp or buy a twin plate or exedy" posts will be ignored. The trick here is to get my car swapped and making good power for less than $1500 total invested in the entire swap in my rx7. I'm making my own mounts, outsourcing my driveshaft to the lowest cost builder and tuning it myself via "ass dyno" and target afr/egt.

[NoPistons!]

Had this been an sr, question would have been answered already. Come on guys. Need some help here doing good, cheap and fast.


Edit: Oh, i forgot. Most of you run fanboy motors. My bad. I'll just run the 350z pp and six puck and see how it goes. If i had an sr or rb, this would have already been answered.