PDA

View Full Version : 1jz inside s13 experts needed inside!!!!!!

IMPORTIMAGE
11-04-2010, 10:57 PM
Ok here's my issue, the motor's in perfectly flush with the swaybar so it can't go forward anymore....

I have the ebay mount kit and heres how the trans lines up against the mount (yes i bought the OEM toyota supra mount but it's not installed yet).... even before i install the new mount it's no where near where the holes should be lining up....my question is....is the ebay trans mount crap or am i doing it wrong? any ideas on what im doing wrong or what i need to do?? Help would be great!

http://i209.photobucket.com/albums/bb219/bill4458/IMG00002-20101105-0042.jpg?t=1288932545

Here's also where it sits on top....
http://i209.photobucket.com/albums/bb219/bill4458/IMG00003-20101105-0121.jpg?t=1288934636
caspa
11-04-2010, 11:45 PM
"EBAY"

msglength.
IMPORTIMAGE
11-04-2010, 11:58 PM
"EBAY"

msglength.

I know i know, but i read good reviews and noone seems to complain... it's not the ebay kit the motor is sitting perfect. I know get it!
Sileighty_85
11-05-2010, 01:19 AM
Not sure how well the shifter hole is suppose to line up, but if the engine is sitting where its suppose to, it looks like the Tranny brace needs to be flipped around
jdm2191
11-05-2010, 01:25 AM
Doesnt look good, are you running a R-154 Trans? Is that the correct tranny mount for your tranny?
IMPORTIMAGE
11-05-2010, 08:05 AM
Doesnt look good, are you running a R-154 Trans? Is that the correct tranny mount for your tranny?

No if you see in my OP i have the correct mount but not installed.....BUT even when i put the correct mount in place it's still not even close to where it needs to be
IMPORTIMAGE
11-05-2010, 01:09 PM
bump.............
JZ78
11-06-2010, 05:54 PM
Try MyJZSwap.com forums...
240sxfamily
11-06-2010, 06:24 PM
try flipping that cross member around..
jodett
11-06-2010, 06:46 PM
+1. looks like it just needs to be flipped.
JZ78
11-06-2010, 10:36 PM
Which ebay kit is this?
IMPORTIMAGE
11-07-2010, 01:00 AM
Try MyJZSwap.com forums...

try flipping that cross member around..

+1. looks like it just needs to be flipped.

Which ebay kit is this?

Figured out the issue..... it doesn't need to be flipped.... the problem is.........


On the 1jz/2jz block there are multiple mounting holes on the block and i mounted it too far forward....i feel stupid lol so basically i need to pull it out and move the engine mounts back. Sean @ myjzswap.com is a HUGE help!
JZ78
11-07-2010, 01:30 PM
So what mount kit did you go with? I'm going to be doing the same exact swap.
IMPORTIMAGE
11-08-2010, 04:59 PM
So what mount kit did you go with? I'm going to be doing the same exact swap.

Ebay mount kit. It works just fine :) I'll post pics/start a build thread ones the motor is in place.
JZ78
11-08-2010, 06:43 PM
Sweet, I'll be looking out for your build!