SR Shifter Assembly Help, Pictures Inside

[chris_240sx]

I'm working on swapping a S14 SR into my car and when the motorset arrived, the shifter assembly was taken apart. I'm trying to get it put back together, but can't quite figure it out. I realize the shifter slides into the "cup" with the two rods, but I can't figure out where the rings go. These are the pieces I have:

http://i397.photobucket.com/albums/pp53/chrissizal/IMG00149-20100914-1719.jpg

http://i397.photobucket.com/albums/pp53/chrissizal/IMG00150-20100914-1719.jpg

http://i397.photobucket.com/albums/pp53/chrissizal/IMG00151-20100914-1719.jpg

http://i397.photobucket.com/albums/pp53/chrissizal/IMG00152-20100914-1719.jpg

Any help would be appreciated, I've searched and couldn't find anything that would help me. Thanks

[japslapsilvia]

put the "cup" in the tranny then the "c" clip...the ring with out the small holes...it has a groove it fits into in the tranny then put in the shifter. lastely the snapring goes in and goes below the c clip, holding in the shifter

[chris_240sx]

Okay, thanks! I'll give that a try tomorrow morning.