Sr20det a/c

[sacario175]

Hey everyone, I'm getting in my CODY ACE bracket to use my KA (95-98) in my redtop SR20 engine. I have all my old stuff (compressor, lines, etc.) Is this going to be a hard process in getting this too work? All help is accepted, I'm planning on doing it this weekend. If anyone has done it please give me some tips/advise.

[codyace]

Hey brother!

It's a bolt on and go kit!

Check out:
Gallery :: AC Conversion Brackets (http://www.codyace.com/gallery/brackets) for install pictures for your kit (s14 to redtop) :D

Just remember to grind off the two lower nubs on the factory bracket and yo'll be good to go!

Once you et the brackets on the SR bracket, keep them a bit loose...mock up the compressor, and then tighten them all down for a perfect fit :D PM me if you need any other help!

Thanks again for the wait...trust me, I didn't like holding onto so many pre pays (I had 15 kits total) but I got them all out today, after getting all of the belts in :D You should easily have it by the weekend :D