S15 Subframe, Direct bolt in s13/r32 solid mount bushings

[brainfood]

Sold thanks!

[iLagX]

are you using the s14 camber arm too? or is that a s15?
how is the solid bushing?? alot of sound?

[Om1kron]

legit ass mod right here.

[brainfood]

Dont really notice solid bushings other then it looses a lot of the rear end play. Still bushings for diff and suspension. that is s14 camber arm but s13 should fit also.

[Big Zee]

where did you get the bushings from ?

awesome mod, too rich for me right now :(

[brainfood]

Touge factory did a run a long time ago. Dont think its something they normally sell though?

[iLagX]

i am very interested.. but i want to know how it feel for daily =/

[brainfood]

I never dailyed with it but it shouldn't be too much harsher then subframe bushing spacers

[brainfood]

bump, if you want a welded diff with s14 cover so it bolts right ill toss one in for $50.

[brainfood]

Bump this one up. thanks

[brainfood]

Bump this is still available

[BlueKpS13]

rad. too bad youre not local

[brainfood]

Willing to ship subframe but not sure on cost.

[ixfxi]

you realize the bushings were/are pressed in backwards, right?

you need some sort of plate to secure the bottom end of your subframe.

also, s14/15 subframes are damn near identical, if not identical. i have both.

[brainfood]

it was temp fit in my r32. They are spaced down because the subframe it the frame rails in the r32. I used big washers underneath normally. Couldnt raise it anymore. s13 can go higher.

[singlecamslam]

Man i have solid bushings on my s13 and they are LOUDDDD. I think its because the diff doesnt have the rubber bushigns like the s14.

[Pirate_Freder]

so in an S13 you can flip the bushings?

[Def]

You can't use an S13 toe arm or RLCA on an S14/S15 rear subframe. The subframe mounting points are wider. Just as a heads up for potential buyers.

[brokeAs240sx]

it was temp fit in my r32. They are spaced down because the subframe it the frame rails in the r32. I used big washers underneath normally. Couldnt raise it anymore. s13 can go higher.

Are the washers you used included? were they just washers you bought after the fact or were they part of the touge factory bushings?

Also, how tight are those solid subframe bushings pressed in? i.e. will I be able to take them out & flip them for install in an s13 w/o the use of a press/etc?

[brainfood]

The washers arent part of the kit from touge factory they only sent me bushings. They are pretty tight but they will come out with a hammer dont need a press. With them flipped you wont need the washers.

[brainfood]

Pulled this back out of the car. I am almost positive the s13 and s14 arms are interchangable.