skythegod2010
04-04-2010, 11:32 PM
I just threw a new block into my KA24E and now there's no spark but it cranks.
I got power up until the coil/ control module then it stops. checked the coil and its still good. the control module was changed, along with the crank angle sensor. all fuses in the cabin by the drivers side were changed and the fuses in the engine bay were checked.
I was thinking about running a new line and attaching a fuse/switch to the coil would that be ok?
give me some hints because I'm stumped
I got power up until the coil/ control module then it stops. checked the coil and its still good. the control module was changed, along with the crank angle sensor. all fuses in the cabin by the drivers side were changed and the fuses in the engine bay were checked.
I was thinking about running a new line and attaching a fuse/switch to the coil would that be ok?
give me some hints because I'm stumped