rhd_sw20
05-05-2009, 11:46 PM
Having troubles getting the new setup started and running.
It cranks fine, it does turn over but will stall immediately after.
Got spark, fuel pump is good. No vacuum leaks and all my couplers on my IC piping are all fine. Car was running fine before turbo install.
Set up is
2871r .86
Blacktop S14 SR20
Power FC D-jetro w/Map sensor
Nismo 740s
Im new to Power FCs. I've tried clearing the PFC, and it still has the same effect after. Installed IAT and MAP sensor properly, I just cant track this down, or theres a different way to get the motor set up with the PFC.
Any input?
It cranks fine, it does turn over but will stall immediately after.
Got spark, fuel pump is good. No vacuum leaks and all my couplers on my IC piping are all fine. Car was running fine before turbo install.
Set up is
2871r .86
Blacktop S14 SR20
Power FC D-jetro w/Map sensor
Nismo 740s
Im new to Power FCs. I've tried clearing the PFC, and it still has the same effect after. Installed IAT and MAP sensor properly, I just cant track this down, or theres a different way to get the motor set up with the PFC.
Any input?