View Full Version : z32 tt caliper spacer sizing (help)
iloveturbos
02-04-2009, 09:46 AM
my rims are 18 x 9 +25 offset ..i need too find out what size spacer too run so the caliper does not hit the wheel thanks alot
SoSideways
02-04-2009, 09:49 AM
What kind of spoke design do your wheels have?
Spoke design is more important than wheel offset man...
iloveturbos
02-04-2009, 12:01 PM
my avatar is the wheels that i have ssr minervas really dont know if they are 0 disk or as some call it low disk ...
gaz_moose
02-04-2009, 12:30 PM
r33gtr wheels are 9j et30 and require a 10mm spacer.but it really depends on the wheel design.
what i usually do it jack the car up take the wheel off then lower the car down onto a block of wood under the chassis rail so that it is at ride height
then put the wheel back on the studs at where i think it should be and measure the gap.that should determine what spacer you need
SoSideways
02-04-2009, 01:02 PM
Low disk Minervas are probably going to need a huge spacer to clear it, seeing as blackcoupe said it took a 25mm spacer to clear his Z brakes, and his were the A-disks (normal disk I think).
Here's the post:
http://zilvia.net/f/chat/129865-wheel-fitment-whore-thread-102.html#post2605784
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.