ebay clutches?

[speed_demon]

im needing a clutch for my car but im not wanting to spend to much because in about 3 months ill be doing the sr swap but i do need a clutch with more clamping power than stock because im spraying my car with a 125shot
i was looking at ebay and wanting to know if anybody has used any of them and how the clutches did
please give me your feed back thankyou

[BoostedCoupe]

i have heard of some people having luck with the XTD ebay clutches and the f1spec's. Search on here im sure there is a thread about it.

[projectRDM]

im needing a clutch for my car but im not wanting to spend to much because in about 3 months ill be doing the sr swap but i do need a clutch with more clamping power than stock because im spraying my car with a 125shot
i was looking at ebay and wanting to know if anybody has used any of them and how the clutches did
please give me your feed back thankyou

There is no such thing as an Ebay clutch. There are clutches of various manufacturers sold on Ebay, that's it. Since you failed to mention a name, give a link, or provide any useful information, no one can help you.

[Teddy]

I'm using a XTD stage 3 6 puck for my SR.


Could be the throw-out-bearing, but my car gets stuck in gear and I can't put it in gear. This clutch / bearing are only a few months old.

[VQMaxFan]

You are probably better off getting the clutch "rebuilt" by a local shop than trying to use a cheap ebay clutch. Its probably going to be cheaper too.

[flip3d]

F1 :P

9WDFWiRPHBA

[killab18]

^^i think that said it all. stock clutches are about $150 at like autozone i believe. also have you looked into SBC clutches. I have one of theirs and couldnt be happier. in the car for close to a year and not a single problem. Running 12psi at about 300whp and not a single slip yet. i also have one of their 6 puck setups to hold 720ft tq but havent used that one yet.

[98s14inaz]

There is a company on ebay that is selling the oem nissan clutch kit that comes with the throwout bearing, pilot bushing, pressure plate, and clutch disc. IIRC the price was reasonable too.

[schmauster]

A stock nissan hardbody flywheel and a cheap 300zx stock replacment clutch should hold on.. lots of people having good luck on this setup.. gives more clutch surface area since the hardbody flywheels are 240mm.... Its called a white bunny special

[jrbump]

If you are swapping out in 3 months then just buy an OEM replacement cheapo and lay the fuck off the bottle. LOL.

[chibo]

I'm using a XTD stage 3 6 puck for my SR.


Could be the throw-out-bearing, but my car gets stuck in gear and I can't put it in gear. This clutch / bearing are only a few months old.

I have the same problem with mine, clutch also sometimes gets stuck half engaged but that's only if I dump it from high revs right after I turn the car on. (I like to abuse my car.) :squintd: