twincamgts
10-08-2008, 05:51 PM
Alright guys, this is my first swap of an rb25 into an 1996 240sx model-upon initial koeo check my fuel pump came on so I disconnected the relay on dr side kick panel,proceeded to recheck koeo-fuel pump came on again,so disconnected from pump,rechecked all ok for a couple of seconds then both of my brand new agency rear brake lines got so hot they melted???? So I disconnect my harness from the junction box so nothing will come on only thing connected is the positive cable from the engine compartment fuse panel w/ power wire run from the front to trunck w/ the fuse box being grounded to the block. I don't see any wires that are loose or in contact w/ chasis- I am assuming I need something ground-when I ran koeo-I grounded the jump pack to the trunk latch. If there is anyone that can help it would be greatly appreciated-wanna beat the bag out of the car before it goes away for the winter?????