Presto

My 240sx will start right up and idle good and without dying. at first will be very responsive with the throttle too. BUT If I continue revving the engine overtime (or maybe it’s just the car being warmed up?) there will be bogging issues and after maybe two minutes of it running. I can only get to the higher rpms if I press open the throttle very very slowly. It will bog out and die if I press the gas too fast.

Parts that have been replaced:
Distributor cap
Spark plugs and wires
New Injectors/seals and injector wiring redone
Throttle position sensor
Egr block off plate
Charcoal canister delete
Iacv cleaned
Throttle body cleaned
Fuel pump has rust but it still delivers fuel there is still pressure

I’ve noticed:
Coolant temp sensor and o2 sensor look pretty done for
Exhaust leaks
Can drive car around without problem at low speed low rpm

Newbie in need of advice S.O.S.

Skythe240guy

What about the Mass Air Flow Sensor?

Sent from my Pixel 3 XL using Tapatalk

Presto

After reading this comment I’m went outside and ran the car, and then I removed the maf while it was idling and nothing changed about the idle or throttle response. Does this mean bad maf? Also one of the tiny springs between the connectors on the maf is missing and the other is glowing red

Skythe240guy

Also unplugging maf while idling won't always make a difference

Sent from my Pixel 3 XL using Tapatalk

Presto

I’ll try to unplug it then run it right now

I unplugged the coolant temp sensor and ran it and nothing changed also when I unplugged the maf it revved up then back to how it was then when I plugged it back in the engine revved up then back down again.

Skythe240guy

So what you're saying basically is it still gave the same result of bogging down still?


Sent from my Pixel 3 XL using Tapatalk

anthony_240

Here before you get your ass burned by others to search lol but make sure with your egr block off doesn’t have any vacuum leaks, as well as other vacuum leaks.

KA will bog with a bad o2 and coolant temp sensor. Especially warmed up since it goes into closed loop once warmed up.

Fix your exhaust leaks, that should go without saying


Sent from my iPhone using Tapatalk

Presto

Yeah on this website people hate on us new guys but it’s alright

I’m planning on fixing exhaust but I don’t hear anything coming from egr block off I tightened it as well but definitely should change temp sensor and o2 then because coolant temp sensor wire is cracked and o2 sensor looks like a burnt marshmallow

Skythe240guy

Unplug the maf and run up and down the road. Probably if it's not bogging down after that could be the maf that's what happened with my KA

Sent from my Pixel 3 XL using Tapatalk