s13 coupe rear tail light question.. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

rhdsilvi85 · 07-22-2013, 11:55 AM

ok so im confused.. I rewired my car with jdm wiring because I had some issues with some stuff... on my old car I had an issue with voltage dropping between the two taillights.. I used a volt checker and with my battery being low (12.2volts) at the back rhd driver tail lights it was 11.8v and at the rhd pass side it was 11.3v.. can anyone shed some light on this? also does anyone know what would cause my brake light to work and then stop working? the light on driver works but pass doesn't any tips on how to test? tried to change bulb but that didn't work..

Mikester · 07-22-2013, 12:43 PM

Check all of your grounds.

rhdsilvi85 · 07-22-2013, 07:23 PM

rhdsilvi85 · 07-22-2013, 07:25 PM

these are the two pics I have one is the ground near the rear latch and the other is the issued tail light... I noticed that the green white stripe wire is got solders I don't know if that is stock or not but that could be a issue.

07-22-2013, 11:55 AM	#1
rhdsilvi85 Zilvia Junkie Join Date: Sep 2012 Location: iowa Age: 35 Posts: 530 Trader Rating: (10) Feedback Score: 10 reviews	s13 coupe rear tail light question.. ok so im confused.. I rewired my car with jdm wiring because I had some issues with some stuff... on my old car I had an issue with voltage dropping between the two taillights.. I used a volt checker and with my battery being low (12.2volts) at the back rhd driver tail lights it was 11.8v and at the rhd pass side it was 11.3v.. can anyone shed some light on this? also does anyone know what would cause my brake light to work and then stop working? the light on driver works but pass doesn't any tips on how to test? tried to change bulb but that didn't work..

07-22-2013, 12:43 PM	#2
Mikester Nissanaholic! Join Date: Jun 2007 Location: Kathleen, GA Age: 50 Posts: 1,938 Trader Rating: (0) Feedback Score: 0 reviews	Check all of your grounds. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-22-2013, 07:23 PM	#3
rhdsilvi85 Zilvia Junkie Join Date: Sep 2012 Location: iowa Age: 35 Posts: 530 Trader Rating: (10) Feedback Score: 10 reviews

07-22-2013, 07:25 PM	#4
rhdsilvi85 Zilvia Junkie Join Date: Sep 2012 Location: iowa Age: 35 Posts: 530 Trader Rating: (10) Feedback Score: 10 reviews	these are the two pics I have one is the ground near the rear latch and the other is the issued tail light... I noticed that the green white stripe wire is got solders I don't know if that is stock or not but that could be a issue.