Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > S Chassis

S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15.


Reply
 
Thread Tools Display Modes
Old 04-05-2013, 03:50 AM   #1
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
SR wet plugs, running rich. need another brain, been staring at car too long

Okay here is my issue:
s13 sr20det
Car is running rich. soaks spark plugs, car wont start.
fuel pressure is at 40lbs (a little low, normally runs 42lbs, but we were trying to lean it out some, just to see if it would help)
when I pull plugs, I am getting spark.
740cc injectors don't leak and have a good conical spray pattern
temperature is 12 C
new o2 sensor
new-er temperature gauges
tps is reading the correct ohms
timing is top dead center, stabbed CAS 3 different times, followed FRsports guide
timing reads 0 degrees at IG on/not running, 3 degrees at cranking
injectors read 5-7% duty at cranking
MAF is reading 450-700 mV at cranking

only sensor that i havent checked is knock.
recently went from 2.5inch IC pipes to 3inch

car started this morning, revved awesome, rough-ish idle
now car wont start at all. cranks, but no fire.
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Sponsored Links
Old 04-05-2013, 06:58 AM   #2
jr_ss
Post Whore!
 
Join Date: Dec 2005
Location: Pa
Posts: 6,052
Trader Rating: (34)
jr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nicejr_ss is just really nice
Feedback Score: 34 reviews
Send a message via AIM to jr_ss
Do you have a tune to run those 750's?
__________________
My SR20VET
jr_ss is offline   Reply With Quote
Old 04-05-2013, 07:44 AM   #3
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
yessir, powerfc, tuned professionally.
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 12:49 PM   #4
zerodameaon
Post Whore!
 
zerodameaon's Avatar
 
Join Date: May 2009
Location: Bay Area CA, Sutherlin OR
Age: 33
Posts: 3,289
Trader Rating: (3)
zerodameaon is an unknown quantity at this point
Feedback Score: 3 reviews
What kind of mods do you have to support those injectors? You still can't just slap them on a stock SR and expect a tune to keep them in check. Just for the hell of it try smaller injectors and see if your problem is alleviated some.
__________________
Quote:
Originally Posted by MrMigs View Post
That's a one-way trip to understeer land...
Quote:
Originally Posted by BKdaMoRoN View Post
Maybe you should petition the retards who are paying 5k for an S13.

Need to adjust your idle?
http://zilvia.net/f/s-chassis/395413...-pictures.html
zerodameaon is offline   Reply With Quote
Old 04-05-2013, 02:45 PM   #5
army240
Zilvia Junkie
 
army240's Avatar
 
Join Date: May 2008
Location: Quebec
Age: 36
Posts: 306
Trader Rating: (1)
army240 is an unknown quantity at this point
Feedback Score: 1 reviews
Did you check your injectors O-Rings for leak?
__________________
Life is a beat to beat
army240 is offline   Reply With Quote
Old 04-05-2013, 03:09 PM   #6
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
i have had the 740s since 2008, it ran perfect before. just completed an engine bay tuck/paint.
powerFC 414BN014
to4e
272 BC cams, springs, retainers
FMIC w/3" piping
walbro pump
nismo fpr
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 03:39 PM   #7
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
ill check o-rings shortly.

keep the ideas coming =/
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 05:05 PM   #8
KiLLeR2001
Post Whore!
 
Join Date: Jun 2007
Location: オーランドフロリダ
Posts: 7,955
Trader Rating: (46)
KiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud of
Feedback Score: 46 reviews
Tell me the resistance of the ECU temperature sensor when the car is completely cooled down.
__________________
KiLLeR2001 is offline   Reply With Quote
Old 04-05-2013, 06:16 PM   #9
army240
Zilvia Junkie
 
army240's Avatar
 
Join Date: May 2008
Location: Quebec
Age: 36
Posts: 306
Trader Rating: (1)
army240 is an unknown quantity at this point
Feedback Score: 1 reviews
Quote:
Originally Posted by KiLLeR2001 View Post
Tell me the resistance of the ECU temperature sensor when the car is completely cooled down.
Just to specify to the OP it's the one with 2 wires on it

Also, you could check the temperature on your power FC.
__________________
Life is a beat to beat
army240 is offline   Reply With Quote
Old 04-05-2013, 07:23 PM   #10
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
checking...
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 08:03 PM   #11
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
3.45v at cold
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 08:13 PM   #12
pewpew
Leaky Injector
 
pewpew's Avatar
 
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
pewpew is an unknown quantity at this point
Feedback Score: 5 reviews
Send a message via MSN to pewpew Send a message via Yahoo to pewpew
it is 61 F here currently
__________________
Don't mix booze and car batteries...it gets expensive, quickly.
pewpew is offline   Reply With Quote
Old 04-05-2013, 08:20 PM   #13
KiLLeR2001
Post Whore!
 
Join Date: Jun 2007
Location: オーランドフロリダ
Posts: 7,955
Trader Rating: (46)
KiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud ofKiLLeR2001 has much to be proud of
Feedback Score: 46 reviews
Stock SR is 43psi with vacuum unplugged and 37psi with vacumm plugged in.

Also, timing needs to be set to 15* BTDC. If you're running at TDC than that will cause a rich condition.
__________________
KiLLeR2001 is offline   Reply With Quote
Old 04-06-2013, 12:22 PM   #14
fliprayzin240sx
Man w/ CTSV & a Car Seat
 
fliprayzin240sx's Avatar
 
Join Date: Aug 2002
Location: Tampa
Posts: 17,998
Trader Rating: (19)
fliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfectionfliprayzin240sx is close to perfection
Feedback Score: 19 reviews
Send a message via AIM to fliprayzin240sx
Also, double check to make sure your PFC didnt drop the settings. Make sure your injector settings are still in there.
__________________

If you think Zilvia has too many assholes...
CLICK HERE!!!
fliprayzin240sx is offline   Reply With Quote
Old 04-08-2013, 09:17 AM   #15
shift_down
Zilvia Junkie
 
Join Date: Sep 2012
Location: Tulsa Oklahoma
Age: 31
Posts: 313
Trader Rating: (0)
shift_down is an unknown quantity at this point
Feedback Score: 0 reviews
Quote:
Originally Posted by army240 View Post
Did you check your injectors O-Rings for leak?
This.


Happened to me. You need to pull injectors and check first. Once you figure out the problem, you MUST change the oil or you will spin a bearing.
__________________
Ka24 t3/t04b + Z32MAF + 550 subys + Walbro 255 + enthalpy Tune + 91 octane
shift_down is offline   Reply With Quote
Reply

Bookmarks


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:46 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
vB.Sponsors
Copyright © 1998 - 2019, Zilvia.net™