kikcaffine

I'm wiring in my dcc into my s13 and I've run into an issue I can't figure out. When I run the diagnostic mode on the dcc I'm getting a failure for every sensor that it uses. They are all plugged in and I'm at a total loss as to what my next steps should be short of replacing the climate control unit. If I plug it into the factory harness all the functions work correctly, I can cycle the blower motor speed and move the vents around between the floor and what not, just not actually have any of the sensors work and recognize. Is this a fairly common issue that just replacing the unit should solve?

supersayianjim

in for answer also??

__________________
http://www.240sxforums.com/forums/rb...ject-s-rb.html

kikcaffine

Any ideas anyone?