Emperor Luna

Hi there I have a question that may get me flamed but w/e. I have searched and since I couldn't get the answers I wanted I'm asking for help now. I have a zenki that I got kouki headlights for after I hit a deer. I have HIDs wired up already and as some of you already know where this is going my low beams shut off when I turn on my high beams as proof I've done my research I found this



So get a 30amp 5 pin relay. (repeat for each side)

Pin 30 goes to the low beam projector
Pin 85 goes to the high beam power
Pin 87a goes to the high beam power
Pin 87 goes to the low beam power
Pin 86 to ground

Other thing to consider is that the load on the high beam wiring may be too much to run both sets of lights. in that case connect
pin 87a to the battery (important use a fuse).

My problem is I've never used relays and I don't know if I'm supposed to cut anything
If someone could please guide me in the right direction it would be greatly appreciated and pictures would be most helpful if you've already done it that way it would give me visual aid and make my life easier