Throw Out Bearing sleeve? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

pssht · 07-03-2008, 12:56 PM

my question is, i pulled off my throw out bearing, and inbetween the bearing retainer and the input shaft is a sleeve, it seems out of place?

it was pushing up against my clutch creating a large crevis and seemed to be causing the throw out bearing to not fully ingauge?
Thanx
-Daelen-

dino6192 · 07-03-2008, 07:17 PM

I'm not sure if your talking about the same part, but I had a problem last year with that "sleeve" that the T.O. bearing sits on broke off! Luckily the KA part is the same and "sds13coupe" came thru with that!

07-03-2008, 12:56 PM	#1
pssht Zilvia Junkie Join Date: May 2007 Location: THE MIDWEST......... Posts: 372 Trader Rating: (7) Feedback Score: 7 reviews	Throw Out Bearing sleeve? my question is, i pulled off my throw out bearing, and inbetween the bearing retainer and the input shaft is a sleeve, it seems out of place? it was pushing up against my clutch creating a large crevis and seemed to be causing the throw out bearing to not fully ingauge? Thanx -Daelen-

07-03-2008, 07:17 PM	#2
dino6192 Zilvia Addict Join Date: May 2008 Location: California Posts: 770 Trader Rating: (8) Feedback Score: 8 reviews	I'm not sure if your talking about the same part, but I had a problem last year with that "sleeve" that the T.O. bearing sits on broke off! Luckily the KA part is the same and "sds13coupe" came thru with that! __________________ Tsuiso.Style @ Instagram

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode