.jrmyrmx

i posted something about this a while back but didnt get any answers.

ok, i have a sr swapped 240sx (i did not perform the swap) with a few bolt-ons. i did a wiretuck by extending the wires to the injectors, the throttle position sensor, temp sensor (right next to the throttle position sensor plug), the camshaft angle sensor and the radiator temp sensor.



all the arrows point to places i extended wires. i used 16 guage wire and all the connections are soldered and taped. the engine looks a bit messy since ive been taking apart my wiring to check for errors.

after my wiring the car started fine but a few days later it wouldnt start when the engine was hot. i had to wait at least 30min to start it after running. then i changed the oil and the oil filter using a greddy air filter and casterol syntec 5w-30 oil. now it wont start at all, it cranks but doesnt turn over.

any suggestions, ideas or insight woul help greatly.