Options13

So i am in the middle of installing an alarm, and i am trying to wire up the remote start part and i am a bit confused.. There is a key side and a car side?

when it refers to key side does that mean the side that is on the left hand side of the steering wheel connected to the key cylinder? and car side is the other harness on the other side that connects to the key cylinder harness?

If so, i should have the remote start wired right

H3 Remote Start Harness

H3/1 Pink (+) Ignition 1 input/output -->BLACK/RED at ignition harness

H3/2 Red/White (87) Flex Relay input (30A Fused) --> WHITE at ignition harness (the one that test as 12volt constant)

H3/3 Orange (+) Accessory output --> not use

H3/4 Violet (+) Starter output car side --> to black/yellow, ignition harness car side

H3/5 Green (+) Starter input key side --> to black/yellow, ignition harness key side

H3/6 Red Ignition 1 input (30A fused) --> to white, ignition harness key side WHITE at ignition harness (the one that test as 12volt constant)

H3/7 Pink/White (30) Flex Relay output --> Cut the non constant 12v WHITE wire at ignition harness, this goes to NON key side

H3/8 Pink/black (87a) Flex relay input --> Cut the non constant 12v WHITE ??wire at ignition harness, this goes to key side -----> there is no white wire on the key side, if i match up the pin with the non key side it's actually a red wire.. refer to pics.

H3/9 Red/black accessory/starter relay input (30A fused) --> WHITE at ignition harness (the one that test as 12volt constant)





help!

__________________
Drift team page
www.facebook.com/savageimpression