|
Home | Rules & Guidelines | Register | Member Rides | FAQ | Members List | Social Groups | Calendar | Mark Forums Read |
S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15. |
|
Thread Tools | Display Modes |
04-16-2012, 06:36 PM | #31 | |
Zilvia Addict
|
Quote:
KA-T.org - The Home of 1000+ whp/7 sec Turbo KA's |
|
Sponsored Links |
04-16-2012, 11:02 PM | #32 |
Premium Member
Join Date: Sep 2006
Location: Bremerton, WA
Age: 36
Posts: 2,037
Trader Rating: (23)
Feedback Score: 23 reviews
|
weight reduction is always free. you could start on the interior, removing carpeting, seats, sound dampening.... theres this whole '10lbs is 1hp' thing..
|
04-16-2012, 11:30 PM | #34 |
Zilvia Addict
|
i have a 3 inch pipe from under the stock air box to a hole that i drilled under the left front turn signal. this creates a true cold air intake and it cost about 12 bucks. also welded a pipe connecting the front strut rod mounts together. nismo sells them, but i have the pipe and a welder so i just did it myself. don`t gut the cat. you will lose enough bottom end to notice and there really is no gain at all. advance the ignition timing at idle with out disconnecting the tps to about 20 degrees before top dead center. this will give you more bottom end. but you have to run 91 octane or higher.
|
04-17-2012, 06:11 AM | #35 |
Leaky Injector
Join Date: Apr 2011
Location: Norwalk CT
Age: 36
Posts: 120
Trader Rating: (0)
Feedback Score: 0 reviews
|
I remember seeing a mod to eliminate the speed limiter and rev limiter you have yo splice a on/off switch on the 5th gear sensor wire and if done correctly you can rev past the limiter and it allows you to go past the 117 mph mark with the flick of a switch, only down side is you loose speedometer reading when switch is off. I've don't this a while ago and don't remember where I saw the write up but it does work. I was able to get 128mph @6700 rmp on a bone stock single cam ka
|
04-17-2012, 06:51 AM | #36 |
Zilvia Junkie
Join Date: Aug 2011
Location: Baton Rouge, Louisiana
Posts: 582
Trader Rating: (2)
Feedback Score: 2 reviews
|
But in all seriousness, there really isn't any "cheap" "mods". Those two words just don't go together. Gut your interior if it doesn't bother you, and save up because you get what you pay for. |
04-17-2012, 12:05 PM | #38 | |
Zilvia Addict
Join Date: Aug 2011
Location: Garden Grove, CA
Age: 36
Posts: 969
Trader Rating: (12)
Feedback Score: 12 reviews
|
Quote:
but yeah, better job mod makes it a whole lot easier. Now I don't have to play with cheap arms and cheap suspension and cheap crap that made me sold the car. |
|
04-17-2012, 01:15 PM | #39 | |
Zilvia Addict
Join Date: May 2008
Location: Missouri City, TX
Age: 38
Posts: 997
Trader Rating: (2)
Feedback Score: 2 reviews
|
Quote:
so true.
__________________
|
|
04-17-2012, 03:07 PM | #41 |
Post Whore!
Join Date: Jan 2008
Location: LAND of the LOST
Posts: 4,082
Trader Rating: (92)
Feedback Score: 92 reviews
|
you cant be serious..you bought a 240 for what reason?
1. after Tokyo Drift 2. traded/sold your honda, gave up your fanboi ways to infect another platform damn its been known for a long time effing 240s need a lot of work,time and money..as with any other car. whether you spend $5 or any x amount your still spending and it all adds up. asking for cheap mods just shows your true juvenile ways. |
04-17-2012, 03:49 PM | #42 |
Join Date: Jan 2005
Location: South Florida
Age: 37
Posts: 47
Trader Rating: (0)
Feedback Score: 0 reviews
|
Ok well I'm bored so I'll bite.
Unless you have a track car and not a daily then all you can really do is gut the interior. If you want you can remove the a/c system but that's really up 2 you. For low cost mods I would suggest you seriously spend the first few dollars to maintain the car. For a few bucks you can get anyone of the following. 1. Seafoam (many good uses) 2. Oil change (use along with seafoam to help clean out the system) 3. Diff oil change (assuming you have a vlsd if not just wait till you get a diff) 4. Check your pads and rotors (if you need to replace spend the extra couple dollars and flush the brake lines) 5. Check p.s. fluid, clutch master and coolant 6. Flush out rad if needed 7. Replace belts 8. Degrease engine and engine bay This is all for now. No point in doing mods to a car or motor that won't last. Crawl before you run and oh yeah Look here for more good info Google |
04-18-2012, 01:47 PM | #44 |
Post Whore!
Join Date: Apr 2006
Location: bangin on my chest Account: BANNED #fucksupreme
Age: 79
Posts: 5,923
Trader Rating: (3)
Feedback Score: 3 reviews
|
things you can do when you're broke:
1) look for a job 2) hang out outside on the front porch 3) watch judge judy yell at people equally as ignorant and pathetic as your half-job, low-income bringing ass 4) visit zilvia using your parents computer and internet connection 5) sell parts off of your car in order to lighten it (because racecar) then after being low-balled by zilvians, blow your $67.21 on cigarettes and beer things you can do when you have money: 1) laugh at poor people (ie: zilvians or ae86 owners) 2) throw a party with lots of drugs (cocaine preferred), invite the iron sheik & beetlejuice 3) have wild orgies at your coke party (have iron sheik fuck people in the ass, make them humble) 4) possibly build a car, if you have the skills to match or know the right shop 5) *.* |
04-18-2012, 01:52 PM | #45 | |
Post Whore!
Join Date: Apr 2006
Location: North Jersey
Posts: 5,481
Trader Rating: (55)
Feedback Score: 55 reviews
|
Quote:
That is the best answer. Ps. Screw you I dont fall in this jersey category you speak of lol. |
|
04-18-2012, 01:59 PM | #46 | |
Zilvia FREAK!
Join Date: Apr 2011
Location: Anaheim CA
Age: 35
Posts: 1,491
Trader Rating: (19)
Feedback Score: 19 reviews
|
Quote:
And wake up to a sexy thang like this
__________________
. |
|
04-18-2012, 02:12 PM | #48 | |
Post Whore!
Join Date: Jul 2005
Location: long beach, CA ^_^
Age: 36
Posts: 2,877
Trader Rating: (29)
Feedback Score: 29 reviews
|
Quote:
__________________
@adrianfromthecastle |
|
04-19-2012, 04:14 PM | #49 |
Zilvia Member
|
This was everything I was thinking when I read this... lol.
__________________
|
04-19-2012, 10:43 PM | #51 | |
Zilvia Member
Join Date: Aug 2011
Location: Augusta, Ga
Age: 30
Posts: 259
Trader Rating: (0)
Feedback Score: 0 reviews
|
Quote:
This guy is my new friend hahaha. This is the best troll thread ever Make a retarded huge rocket bunny look-a-like wing with sheet metal. |
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|