ka idles at 3k - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Slammed Assassin · 08-06-2008, 02:38 AM

(backround info) I dropped in a dual cam ka because i my sohc blew..i had to do the timing chain so I put the first piston at TDC and installed the chain.. i got eveything installed in the car and started it up.

Could using a sohc ignition coil be part of the problem?

Problems.
-The motor idles at 3000,
-Motor shakes like crazy,
-Drove it around the corner and it feels like theres no power at all.(Slower than a golf cart slow.)
-Los of backfiring..

hitman · 08-06-2008, 03:57 AM

where you able to set the timing with a light? my friends dad did my timing chain and said it wasnt off because he was able to get it to factory timing with the distributor no problems. check with a timing light to see if you can get it close. i dont know though, because at 3k the timing would be different. maybe something is up with the throttle body and the cable. id check that out too. and vacuum leaks

jdmdrft · 08-06-2008, 11:26 AM

ehh my motor shook really bad but turns out the rotor was bad. was even getting spark on one cylinder and it was slow. replaced the distributor, cap, and plugs and runs like a champ. as for the idle idk man.

drftthatshit · 08-06-2008, 12:10 PM

check you tps sensor on the throttle body if that is way off it will cause the car to idle high or low also do what the rest of the guys said to its cheap and can only aid to fixing your problem

blueshark123 · 08-06-2008, 12:22 PM

nevermind read wrong

SHIFT_*grind* · 08-06-2008, 12:23 PM

World's largest vacuum leak?

Slammed Assassin · 08-21-2008, 11:40 PM

(update).. i gave up for a while but i just want to get this done...i noticed that if i rev up the motor the idle stays at the rpm i reved it up to..then i noticed that if i push foward the throttle by hand in the engine bay the idle goes down to 1k.(i ajusted the throlle cable too to see if it would help. but no fix).any suggestions will be useful..thanks...

Leetheslacker · 08-22-2008, 12:37 AM

sounds like the throttle plates all nasty and sticky?

JRas · 08-22-2008, 01:20 PM

did you use the SOHC throttle cable? or are you using a DOHC throttle cable?

Slammed Assassin · 08-22-2008, 09:08 PM

im using a DOHC throttle cable..

1slowS13 · 08-22-2008, 10:08 PM

your probably leaking between the intake manifold and head

08-06-2008, 02:38 AM	#1
Slammed Assassin Nissanaholic! Join Date: Feb 2007 Location: Oxnard/SV Posts: 2,065 Trader Rating: (34) Feedback Score: 34 reviews	ka idles at 3k (backround info) I dropped in a dual cam ka because i my sohc blew..i had to do the timing chain so I put the first piston at TDC and installed the chain.. i got eveything installed in the car and started it up. Could using a sohc ignition coil be part of the problem? Problems. -The motor idles at 3000, -Motor shakes like crazy, -Drove it around the corner and it feels like theres no power at all.(Slower than a golf cart slow.) -Los of backfiring.. __________________

08-06-2008, 03:57 AM	#2
hitman Zilvia FREAK! Join Date: Mar 2006 Location: late 19th century prussia Age: 34 Posts: 1,057 Trader Rating: (3) Feedback Score: 3 reviews	where you able to set the timing with a light? my friends dad did my timing chain and said it wasnt off because he was able to get it to factory timing with the distributor no problems. check with a timing light to see if you can get it close. i dont know though, because at 3k the timing would be different. maybe something is up with the throttle body and the cable. id check that out too. and vacuum leaks __________________ driftparty.com

08-22-2008, 01:20 PM	#9
JRas Zilvia FREAK! Join Date: Jul 2007 Location: Arizona Age: 32 Posts: 1,503 Trader Rating: (2) Feedback Score: 2 reviews	did you use the SOHC throttle cable? or are you using a DOHC throttle cable? __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-06-2008, 11:26 AM	#3
jdmdrft Zilvia Member Join Date: Mar 2008 Location: Arkansas Age: 28 Posts: 151 Trader Rating: (1) Feedback Score: 1 reviews	ehh my motor shook really bad but turns out the rotor was bad. was even getting spark on one cylinder and it was slow. replaced the distributor, cap, and plugs and runs like a champ. as for the idle idk man.

08-06-2008, 12:10 PM	#4
drftthatshit Zilvia Member Join Date: Jul 2008 Location: fox lake Age: 33 Posts: 192 Trader Rating: (0) Feedback Score: 0 reviews	check you tps sensor on the throttle body if that is way off it will cause the car to idle high or low also do what the rest of the guys said to its cheap and can only aid to fixing your problem

08-06-2008, 12:22 PM	#5
blueshark123 Post Whore! Join Date: Apr 2006 Location: North Jersey Posts: 5,481 Trader Rating: (55) Feedback Score: 55 reviews	nevermind read wrong

08-21-2008, 11:40 PM	#7
Slammed Assassin Nissanaholic! Join Date: Feb 2007 Location: Oxnard/SV Posts: 2,065 Trader Rating: (34) Feedback Score: 34 reviews	(update).. i gave up for a while but i just want to get this done...i noticed that if i rev up the motor the idle stays at the rpm i reved it up to..then i noticed that if i push foward the throttle by hand in the engine bay the idle goes down to 1k.(i ajusted the throlle cable too to see if it would help. but no fix).any suggestions will be useful..thanks...

08-22-2008, 12:37 AM	#8
Leetheslacker Zilvia Junkie Join Date: Jul 2005 Location: ohio Posts: 382 Trader Rating: (1) Feedback Score: 1 reviews	sounds like the throttle plates all nasty and sticky?

08-22-2008, 09:08 PM	#10
Slammed Assassin Nissanaholic! Join Date: Feb 2007 Location: Oxnard/SV Posts: 2,065 Trader Rating: (34) Feedback Score: 34 reviews	im using a DOHC throttle cable..

08-22-2008, 10:08 PM	#11
1slowS13 Zilvia Junkie Join Date: Jan 2008 Location: Las Vegas, NV Age: 32 Posts: 466 Trader Rating: (6) Feedback Score: 6 reviews	your probably leaking between the intake manifold and head