Help me id these plugs! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

AznXstazy · 09-27-2009, 09:13 PM

hey guys, I'm trying to attempt a wire tuck, but when i started to ID the plugs that i needed to extend i started noticing plugs that I didn't label before pulling it into the cabin =/

Trying to figure it out, but the service manuals not helping to much. Trying to see if anyone on here knows what they are off the top of their heads.

DRIVER SIDE FRONT FUSE BOX

http://i24.photobucket.com/albums/c6...t/fusebox2.jpg

found this close to my fuse box when i got my car with a sr20 swap in it. it was zip tied together already. looks like a MAF connector?

IGNITOR CHIP

http://i24.photobucket.com/albums/c6...ot/ignitor.jpg

i know that's the ignitor chip, but what are the 2 sensors that are next to it? looks like a boost solenoid? and the other looks like a EVAP sensor?

PASSENGER SIDE FUSE BOX AREA

http://i24.photobucket.com/albums/c6...sidfusebox.jpg

I know 1 and 2 goes to the engine harness, but not sure what 3 and 4 goes to.

PASSENGER SIDE AREA
http://i24.photobucket.com/albums/c6...rsidefront.jpg

this is where most of the plugs that I'm not sure of. i THINK 2 and 3 are for the windshield wiper fluid motor, but that was removed by the previous owner and those plugs were just dangling there. 5 is a relay to something.. and the rest of them not really sure.

I will be checking the FSM again and try to figure out most of them, but the previous owner did a real hack job =/

any help will be greatly appreciated thanks guys.

JRex · 09-27-2009, 10:15 PM

Picture #1
1. Not sure what it is, but it's not needed.
2. I believe that is the PS Switch plug. MAFs are usually have 3 little connectors in them.

Picture #2
1. Boost Solenoid
2. EGR Sensor
3. Igniter

If I figure out anymore I'll post them up.

AznXstazy · 09-27-2009, 11:27 PM

thanks a lot JRex. still looking through the FSM trying to figure them out. i have this posted in nico to. so if anyone on there has any ill post them up here.

AznXstazy · 09-28-2009, 10:04 PM

bump bump bump

projectRDM · 09-28-2009, 10:16 PM

Wire colors would help, especially since you can match it to the FSM that way.

Picture #1 is the AIV and A/C compressor.

Picture #2 is as discussed, boost solenoid and control valve.

Picture #3 is lower harness, alternator, starter, and A/C drier.

Picture #4 is starter relay, wiper washer motor, few other things. Hard to tell with those pics.

The FSM has a layout of all the plugs and locations. But you do have to read it a little.

AznXstazy · 09-29-2009, 09:03 AM

thanks project. been looking at the FSM, but i have the japanese version so its kinda hard to read. anyone have the english version?

AznXstazy · 10-01-2009, 09:09 AM

anyone else? still can't find the english FSM. but i seen post were people said they have it.

AznXstazy · 10-04-2009, 08:46 PM

anymore help would be appreciated thanks guys.

09-28-2009, 10:16 PM	#5
projectRDM Post Whore! Join Date: Dec 2002 Location: Atlanta Age: 47 Posts: 13,812 Trader Rating: (12) Feedback Score: 12 reviews	Wire colors would help, especially since you can match it to the FSM that way. Picture #1 is the AIV and A/C compressor. Picture #2 is as discussed, boost solenoid and control valve. Picture #3 is lower harness, alternator, starter, and A/C drier. Picture #4 is starter relay, wiper washer motor, few other things. Hard to tell with those pics. The FSM has a layout of all the plugs and locations. But you do have to read it a little. __________________ FORMERLY R240NA Learn what's really going on and protect your assets now before they're gone forever: www.paypalsucks.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-27-2009, 09:13 PM	#1
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	Help me id these plugs! hey guys, I'm trying to attempt a wire tuck, but when i started to ID the plugs that i needed to extend i started noticing plugs that I didn't label before pulling it into the cabin =/ Trying to figure it out, but the service manuals not helping to much. Trying to see if anyone on here knows what they are off the top of their heads. DRIVER SIDE FRONT FUSE BOX http://i24.photobucket.com/albums/c6...t/fusebox2.jpg found this close to my fuse box when i got my car with a sr20 swap in it. it was zip tied together already. looks like a MAF connector? IGNITOR CHIP http://i24.photobucket.com/albums/c6...ot/ignitor.jpg i know that's the ignitor chip, but what are the 2 sensors that are next to it? looks like a boost solenoid? and the other looks like a EVAP sensor? PASSENGER SIDE FUSE BOX AREA http://i24.photobucket.com/albums/c6...sidfusebox.jpg I know 1 and 2 goes to the engine harness, but not sure what 3 and 4 goes to. PASSENGER SIDE AREA http://i24.photobucket.com/albums/c6...rsidefront.jpg this is where most of the plugs that I'm not sure of. i THINK 2 and 3 are for the windshield wiper fluid motor, but that was removed by the previous owner and those plugs were just dangling there. 5 is a relay to something.. and the rest of them not really sure. I will be checking the FSM again and try to figure out most of them, but the previous owner did a real hack job =/ any help will be greatly appreciated thanks guys.

09-27-2009, 10:15 PM	#2
JRex Zilvia Junkie Join Date: Apr 2009 Location: Gainesville, FL Age: 33 Posts: 354 Trader Rating: (5) Feedback Score: 5 reviews	Picture #1 1. Not sure what it is, but it's not needed. 2. I believe that is the PS Switch plug. MAFs are usually have 3 little connectors in them. Picture #2 1. Boost Solenoid 2. EGR Sensor 3. Igniter If I figure out anymore I'll post them up.

09-27-2009, 11:27 PM	#3
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	thanks a lot JRex. still looking through the FSM trying to figure them out. i have this posted in nico to. so if anyone on there has any ill post them up here.

09-28-2009, 10:04 PM	#4
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	bump bump bump

09-29-2009, 09:03 AM	#6
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	thanks project. been looking at the FSM, but i have the japanese version so its kinda hard to read. anyone have the english version?

10-01-2009, 09:09 AM	#7
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	anyone else? still can't find the english FSM. but i seen post were people said they have it.

10-04-2009, 08:46 PM	#8
AznXstazy Zilvia Member Join Date: Apr 2006 Location: Bleh Posts: 154 Trader Rating: (2) Feedback Score: 2 reviews	anymore help would be appreciated thanks guys.