turbob16ef

Well been beating on the motor for about 2 years now and some how oil drain plug came loose and splooged all over the road. So attempting JZ motor set.

Located in Beaufort, sc. 29907. More than welcome to come take a look. And will ship at buyers expense. And everything for the most part is obo. take trades for 1j or 2j swap/parts, Sum seats, cage, chargespeed rear overs(s14). Etc.....

S14 (knotch back) sr20. 70,000ish. OBO
Is still starts, drives, no knocking, ticking or anything. Just smokes. Haven't check comp or leak down. Obo
Greddy s13 sr pullies. Alt, ps, wp. Water pump has .5in scratch where belt slipped. 250obo
125 amp quest alternator(70k) w/ codyace bracket(50miles) temporarily on hold.
Bnib mazworx plenum spacer. sold to pblesh85.
S14sr into s14 harness. 200obo.
S14 sr trans rebuilt. Roughly 7k on it. 250obo
Spec d clutch setup. Needs new disk. Will part out pp/flywheel. 500obo
Nismo slave cylinder. Roughly 7k. 125obo
Agency power clutch line. Bnib. 40obo
Stock 2 peice non abs driveshaft. 100obo
Peak performance red trans mount. Roughly 7k. 50obo
Nismo motor mounts. roughly 7k. Sold to s14freak
Apexi dual n1 (s14). Alil beat up on resonator from being low. Other than that really clean. Sold to s14freak
Greddy 80mm downpipe. Scrapped on bottom. 130obo.
GtSpec turbo outlet. Very clean. Sold to romero8287
S14 t28/hks gate/ with stock manifold, mileage unknown. Spooled good, no smoke. Had on my other sr in other car, swapped for gt30. 500obo
DIF oil/coolant lines with restrictor. S13sr. 120obo
Hks mushroom filter connected to good working s14 sr maf. 150obo
Mishimoto radiator, has been patched where something rubbed it. Has 2 electric fans. 1 12" and 1 14". Sold to glitch240sx
Samco blue radiator hoses. Been trimmed alil for mid mount setup. Sold to glitch240sx
Tomei s13 sr 270 cams. Exhaust has a slight knick from rocker getting thrown. (how I received, machine shop said it will not effect anything. Have about 2k on them. Made 630 with these cams. 300obo.

Peakboost setup has roughly 2500 miles on it. Last person made 630 on this setup.
Peakboost t3 top mount sr exhaust manifold
Peakboost 3in downpipe (modified) has flex pipe fitted for slammed peoples and egt sensor fitting. Vbands to stainless 3in to welded Megan test pipe to stock location catbck. Piping is cunt hair above the frame rail. Very minor scratches from me living in a neighborhood with 5 stupid speed bumps.
Peakboost dump tube.
1000 shipped or obo + shipping.
1050 shipped with one of the tials
1200 shipped with tial bov and gate.

2 Tial 38mm gate.
First has 150 miles. 200 shipped
Second has 2000. 150 shipped
Both tials for 250 shipped.

T3/67 spa turbo. .63 exhaust housing 90* elbow welded on. Roughly 750miles. Sold to Jwrose.




HKS Mid mount intercooler setup.
Was originally a complete HKS s type kit. Baller edition. Lol. Hacked it up and made into big ass mid mount.
Fits under radiator support, just need to trim support alil. Enough room for AC condenser.
Cools better than when it was front mount. Drastic temp drops.
One peice 2.75in aluminum cold side. Has gm ait fitting welded right before tb.
2.5in aluminum hot side. Tial 50mm flange.
Tial v.1 50mm bov. Polished. Roughly 200 miles (only want to sell with piping).
1000obo with tial.
900obo without.

AEM version 1 for s14 sr. 300miles on it.
Gm 3 bar map sensor 300miles
Gm ait sensor 300miles
Mac boost solenoid 300miles-keeping
Sold to Dil Han


Bnib injector dynamic 1000cc injectors- 450shipped
Bnib jgy duel feed rail. 8an fuel line from fire wall to strut tower, to Jegs mini filter, to purple magnum Y fittings 8an to 6an, 6 an lines to fuel rail.
350obo
Aeromotive fpr. 6an fitting/6an line to center of rail. 500miles. - 120 shipped


Autometer cobalt egt gauge. With sensor. Has 200miles.
120obo

Also have a authentic full version select type 1 kit. Pretty clean, front bumper has 2 3in cracks(ziptied). Side have scrapes from being low and speed bumps( why I went back to stock) 600obo.
Have some ati side skirts. Got them in a package deal. Don't know which model. 150 obo.

I think there's more ill add it as I remeber.
Has taken me 3hrs do make this list.

turbob16ef

Atleast my toes are clean. Lol.




NEW PICS





You can see the flex was relocated for being slammed. Lol.

That's all the piping for the midmount setup.

Spec D clutch. The disk needs replaced or new rivets. Still grabbed very good, didn't know it was loose till I removed it.

Mishimoto rad with 14/12" fans. Samco rad hoses.

Hks s type cooler flipped and made into huge midmount

Motor. Lol. You can see the scratch on the wp pulley. And th VC is powder coated, but it is dirty in pic.

Rebuilt trans 7kish. Has short shifter (Isis?? Jdm?? Type r??) I don't know. Shifts awesome, no grinds,pop outs, monsters.

That's the rest of the downpipe, catless, and vband a to the upper part. Was a Megan test pipe just made better. Lol. Has 02 bung on rear part of dp.

Here's the brain, aem ems v1. Has maybe 300miles on it. Shitty pic but you get the idea.

SharkMan

Damn wish I had the cash at the moment.

__________________

turbob16ef

Pics added. Will add more when I can.

turbob16ef

Bump. Everything is obo. Throw me some offers.

Seraphim38

free bump for a legit setup. I would buy the top mount turbo setup but this sale catches me at a bad time.

turbob16ef

Thanks....
Msglgth

turbob16ef

Bump......
I need money. Everything is obo. Pretty negotiable on everything.

ForeignMuscle

Post some pics bud. The links are deleted or broken. I'm interested in some of the big boy parts..

turbob16ef

Yeah, I'm trying to fix it now. Hopefully have them uploaded again in couple mins.

JFoxx

interested in your 2 tial wastegates..... what springs do you have for them? are they v-band? how much shipped to 91910? pm me plz....

huffandpuff00

Would you part the tial 50mm bov?

Zac

romero8287

Bump, this guy is legit.... I trust him any day to work on my s13.....

NickIsAZero

Hey man I still got my 1j with mounts & driveshaft... Wanna workout some trades?

romero8287

Well let me tell you , I have seen everything he has for sale and all the parts are legit . for big boy's that want serious hp...

turbob16ef

Thanks Andy. I'll give you a call Ina bit. Was busy all day yesterday, packing to move.

240boi115

how is it that every time im hurting on money..sick shit like this pops up...-__-

turbob16ef

Throw some offers you might be surprised. Just be reasonable.

romero8287

Bump !!!!!!!!!!!!!!

romero8287

come ppl help out.. BUMP!!!

K_style

PM'd ya...

turbob16ef

replied....

romero8287

Weekend bump!!!!!

turbob16ef

Still have most this stuff. Lets get it sold. Throw some offers.

mulinjohe

Throw some offers you might be surprised. Just be reasonable.

Riodcs

How much for tial bov and aeromotive fpr

headup240

What part of sc are you in? I'm in charlotte I would like to get that radiator

turbob16ef

I'm located down in beaufort/ Hilton head area. Charlotte is roughly 3.5hrs.

Returning PM's after this message.

ForeignMuscle

Are the cams solid or hydraulic type?

turbob16ef

I was told there were hydrolic. I can get the part numbers and post them.