-10 oil return line- what do i weld to the pan? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

gotta240 · 07-07-2008, 01:33 AM

I will be running a -10 oil return line from my t25 ka-t. I don't have the lines with me, nor do i know much about them.

What do i need to weld into my oil pan so i can easily connect the -10 line later? I know JGS sells a 1/2 threaded fitting, but is that the best/most used route to connect to -10an?

Also, can i use a threaded portion from like home depot or are they threaded differently?

thanks

hunter8411 · 07-07-2008, 01:47 AM

Does your -10 line already have ends to it? Or are you going with AN fittings?

I went KA-T and bought this fitting and had it welded to my oil pan.

http://www.anplumbing.com/shop/images/997110.jpg

then bought a AN fitting from a local shop for the -10 line to thread onto the newly welded fitting.

http://www.anplumbing.com/shop/images/6487_165106.jpg

They were all -10 so it was real clean and simple. If the -10 line already has a male or female end on it, I'm sure you can find which weld on bung you need at

http://www.anplumbing.com/shop/index...dept=Weld!_Ons.

Hope that helped.

gotta240 · 07-07-2008, 10:52 AM

Great reply. Thanks and repped.

07-07-2008, 01:33 AM	#1
gotta240 Post Whore! Join Date: Dec 2005 Location: so cal Posts: 3,496 Trader Rating: (21) Feedback Score: 21 reviews	-10 oil return line- what do i weld to the pan? I will be running a -10 oil return line from my t25 ka-t. I don't have the lines with me, nor do i know much about them. What do i need to weld into my oil pan so i can easily connect the -10 line later? I know JGS sells a 1/2 threaded fitting, but is that the best/most used route to connect to -10an? Also, can i use a threaded portion from like home depot or are they threaded differently? thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-07-2008, 01:47 AM	#2
hunter8411 Zilvia Addict Join Date: Sep 2005 Location: SoCal Age: 37 Posts: 664 Trader Rating: (20) Feedback Score: 20 reviews	Does your -10 line already have ends to it? Or are you going with AN fittings? I went KA-T and bought this fitting and had it welded to my oil pan. http://www.anplumbing.com/shop/images/997110.jpg then bought a AN fitting from a local shop for the -10 line to thread onto the newly welded fitting. http://www.anplumbing.com/shop/images/6487_165106.jpg They were all -10 so it was real clean and simple. If the -10 line already has a male or female end on it, I'm sure you can find which weld on bung you need at http://www.anplumbing.com/shop/index...dept=Weld!_Ons. Hope that helped.

07-07-2008, 10:52 AM	#3
gotta240 Post Whore! Join Date: Dec 2005 Location: so cal Posts: 3,496 Trader Rating: (21) Feedback Score: 21 reviews	Great reply. Thanks and repped.