shaft separating from Diff - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

sleeper108 · 07-26-2014, 11:13 AM

I couldn't find anything relating to this, so I am sorry if it was somewhere, and I just couldn't find it.

The above picture is what I noticed while I was searching for a speed vibration. I have no idea which is the best way to tackle this, and want to make sure before I do something that ends up being more detrimental than actually fix it.

Can I just press the shaft that is coming out back into the diff? And then I assume I will have to go for an alignment.

like I said, sorry for a noob question, I just don't want to do more harm than good.

jr_ss · 07-26-2014, 11:38 AM

Unbolt the axle and pull the shaft coming out of the diff. Inspect for damage and replace the side seal. If there is no damage to the stub, reinstall it. It should "click" or "snap" into place.

[email protected] · 07-27-2014, 05:18 AM

Possible the c-clip inside has worn down, but it could just be a fluke that it did ...

And no you shouldn't assume you need an alignment

07-26-2014, 11:13 AM	#1
sleeper108 Zilvia Junkie Join Date: Dec 2008 Location: Albuquerque, NM Age: 31 Posts: 511 Trader Rating: (7) Feedback Score: 7 reviews	shaft separating from Diff I couldn't find anything relating to this, so I am sorry if it was somewhere, and I just couldn't find it. The above picture is what I noticed while I was searching for a speed vibration. I have no idea which is the best way to tackle this, and want to make sure before I do something that ends up being more detrimental than actually fix it. Can I just press the shaft that is coming out back into the diff? And then I assume I will have to go for an alignment. like I said, sorry for a noob question, I just don't want to do more harm than good.

07-26-2014, 11:38 AM	#2
jr_ss Post Whore! Join Date: Dec 2005 Location: Pa Posts: 6,052 Trader Rating: (34) Feedback Score: 34 reviews	Unbolt the axle and pull the shaft coming out of the diff. Inspect for damage and replace the side seal. If there is no damage to the stub, reinstall it. It should "click" or "snap" into place. __________________ My SR20VET

07-27-2014, 05:18 AM	#3
[email protected] Leaky Injector Join Date: Sep 2012 Location: Toronto Posts: 126 Trader Rating: (0) Feedback Score: 0 reviews	Possible the c-clip inside has worn down, but it could just be a fluke that it did ... And no you shouldn't assume you need an alignment __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode