Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk > S Chassis

S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15.


Reply
 
Thread Tools Display Modes
Old 06-30-2009, 07:46 PM   #1
spartanic
Leaky Injector
 
Join Date: Aug 2006
Location: Minnesota
Age: 39
Posts: 86
Trader Rating: (0)
spartanic is an unknown quantity at this point
Feedback Score: 0 reviews
Nissan 240sx 1989-1994 S13 Manual Transmission Removal and Installation

Click on the link to see the complete article with images check it out here: Nissan 240sx Manual Transmission Removal and Installation. Garage411.com


LUBRICATION


SERVICE INTERVALS
Inspect tranny fluid level every 15,000 miles or 12 months. If under severe usage, change fluid every 30,000 miles or 24 months.

CHECKING TRANNY FLUID LEVEL
Fill plug is located on side of transmission case. Lubricant level should be to bottom of fill hole. Add fluid if necessary.

RECOMMENDED FLUID
Use Hypoid SAE 75W-90 (API GL-4) gear oil.

TRANSMISSION REFILL CAPACITIES
  • Nissan 240SX S13: 5.1Pts. (2.4L)

Manual Transmission Removal and Installation

Removal
1. Disconnect battery terminals and accelerator linkage. Place shift lever in Neutral position. Remove shift lever boot, snap ring or nut, shift lever pin and shift lever. Raise and support vehicle.
2. Disconnect exhaust pipe from manifold. Remove bolts mounting exhaust pipe bracket to extension housing or rear engine crossmember (if necessary). Remove exhaust pipe insulator. Disconnect all electrical connectors from transmission. Disconnect speedometer cable.
3. Mark drive shafts and companion flanges for installation reference. Separate center support bearing from crossmember. Remove drive shaft. Plug rear of transmission to prevent fluid loss. Remove slave cylinder. Support engine and transmission using jacks. Loosen rear engine mount attaching bolt.
4. Remove rear engine mount bracket. Support transmission. Remove starter and engine-to-transmission bolts. Slide transmission rearward and remove transmission.

Installation
1. Lightly lubricate clutch disc splines with molybdenum grease. Slide clutch disc onto mainshaft splines. Remove clutch disc. Wipe off excess grease. Install clutch assembly onto guide dowels. Use clutch aligning tool to center disc and pressure plate.
2. Using a crisscross pattern, tighten bolts evenly one turn at a time to specification. To complete installation, reverse removal procedure.


Click on the link to see the complete article with images check it out here: Nissan 240sx Manual Transmission Removal and Installation. Garage411.com
__________________

spartanic is offline   Reply With Quote
Sponsored Links
Reply

Bookmarks

Tags
240sx manual transmission, 240sx mt, garage411.com, s13 manual transmission, s13 mt


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:53 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
vB.Sponsors
Copyright © 1998 - 2019, Zilvia.net™