Zilvia electricians unite - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

newkid99 · 01-31-2013, 09:13 AM

So I have a 91 s13 fastback with a ka-de swap from an s14. Motor runs strong and everything works great except for the dash lights, spedo, and stereo... I've narrowed the problem down to an ignition switch wire, solid blue. It runs to the stereo and dash cluster. At first when I hooked up the stereo I was getting a strong 12.7 volts when in the acc or on position, then it just stopped.... And now when I turn the key it will slowly go up to about 3 volts and it does the same on the blue wire behind dash... WTF? Any ideas? I have checked all fuses under the dash and on pass side of the motor, I am lost.

newkid99 · 01-31-2013, 09:15 AM

Yes I have searched.

rcdad123 · 01-31-2013, 09:44 PM

check the stereo fuse holder in the fuse box. i had a wiper stop working on an 89 coupe and after trying on three good fuses, i finally looked at the fuse holder and found that it spread so far apart that it was not touching the fuse at all. i had to close the gap by sticking a pick in it.

redsx13 · 01-31-2013, 11:46 PM

Ok listen up, there are 4-5 wires on a 240 ignition switch the reason i say 4-5 is because s13s have 4 and 14s have 5. So, your entire ignition switch assem. gets power from 1 wire (dont remember the color off hand) which is always hot. then, depending key position, it destributes 12v to each of the other wires (1 for acc, 1 for ign, and one for the startor relay). so that blue wire you are talking about, the acc wire coming from the ignition switch, if there is no power to that wire on the back of the ign switch, then you have a bad ign switch.

01-31-2013, 09:13 AM	#1
newkid99 Zilvia Member Join Date: Jan 2011 Location: St. Louis MO Posts: 167 Trader Rating: (7) Feedback Score: 7 reviews	Zilvia electricians unite So I have a 91 s13 fastback with a ka-de swap from an s14. Motor runs strong and everything works great except for the dash lights, spedo, and stereo... I've narrowed the problem down to an ignition switch wire, solid blue. It runs to the stereo and dash cluster. At first when I hooked up the stereo I was getting a strong 12.7 volts when in the acc or on position, then it just stopped.... And now when I turn the key it will slowly go up to about 3 volts and it does the same on the blue wire behind dash... WTF? Any ideas? I have checked all fuses under the dash and on pass side of the motor, I am lost.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-31-2013, 09:15 AM	#2
newkid99 Zilvia Member Join Date: Jan 2011 Location: St. Louis MO Posts: 167 Trader Rating: (7) Feedback Score: 7 reviews	Yes I have searched.

01-31-2013, 09:44 PM	#3
rcdad123 Zilvia Addict Join Date: Jul 2011 Location: san diego Posts: 639 Trader Rating: (0) Feedback Score: 0 reviews	check the stereo fuse holder in the fuse box. i had a wiper stop working on an 89 coupe and after trying on three good fuses, i finally looked at the fuse holder and found that it spread so far apart that it was not touching the fuse at all. i had to close the gap by sticking a pick in it.

01-31-2013, 11:46 PM	#4
redsx13 Zilvia Junkie Join Date: Jan 2009 Location: Agoura Hills, Ca Age: 31 Posts: 572 Trader Rating: (6) Feedback Score: 6 reviews	Ok listen up, there are 4-5 wires on a 240 ignition switch the reason i say 4-5 is because s13s have 4 and 14s have 5. So, your entire ignition switch assem. gets power from 1 wire (dont remember the color off hand) which is always hot. then, depending key position, it destributes 12v to each of the other wires (1 for acc, 1 for ign, and one for the startor relay). so that blue wire you are talking about, the acc wire coming from the ignition switch, if there is no power to that wire on the back of the ign switch, then you have a bad ign switch.