|
Home | Rules & Guidelines | Register | Member Rides | FAQ | Members List | Social Groups | Calendar | Mark Forums Read |
Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars |
|
Thread Tools | Display Modes |
01-24-2006, 01:17 AM | #1 |
Post Whore!
|
near finished sr swap.. problems
Ok so I got the wiring done, z32 maf and plug wired in, z32 fuel pump, s-afc to control it, all vacum lines etc, everytrhing should rock. However, it doesnt seem to fire up. checked ignitor chip, even got another ignitor chip from a friend and same thing, just cranks from the starter but doesnt fire up. Got fuel so thats not an issue. Pulled a coilpack out and stuck a screw driver in it and got it near the chassis to see if it sparks up, and it bearly sparks (not as often as it should). I followed this for the maf plug wiring http://www.az240sx.org/tech/mafs/z32diagram-correct.jpg and followed nissanperformancemagazine's write up on the harness wiring. http://nissanperformancemag.com/march04/240sr/ Anything I should check for? Im all out of ideas.
__________________
Keep it Classy |
Sponsored Links |
01-25-2006, 02:43 PM | #5 |
Post Whore!
|
got it running,.. just re-seated the ecu in the harness and changed settings on safc.
Good question tho, how the hell do you check timing on a car with coil packs? I think my friend tried checking it but the timing gun doesnt get a signal from these wires?
__________________
Keep it Classy |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|