S13 Exhaust Removal - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

chozobody · 03-31-2013, 07:17 PM

I'm in the process of removing the exhaust from my S13. The previous owner replaced the stock exhaust with some no name headers and a straight pipe. (Middle of Nebraska, what do you expect?) I have all the header bolts removed, and I have all but one of the rubber bushings removed from the rear. I have two spots that I can't figure out though. One spot is a solid metal s-shaped hose, and the other is a slightly bigger, L-shaped hose that looks screwed into the header. I need this out fairly soon so I can put my new motor in. Any advice would be greatly appreciated.
240 - Imgur

foreverdeath · 03-31-2013, 08:03 PM

he s hose is for PAIR, and the u shaped pipe is the egr tube. never that joy to trying to remove these. easyest way i assume would be using a large pipe wrench of vise grips, if you want to keep your emissions.

codyace · 03-31-2013, 08:28 PM

I'm unsure what the lower hose is, but the upper threaded one is your EGR tube.

Unless your state requires emissions it's easier to cut the egr pipe and remove the system off the car (also putting a cap on the EGR valve) and then remove it on the bench (if it even comes out). You can attempt at soaking it in penetrate, but it may be nearly impossible without heat and penetrating oil.

03-31-2013, 07:17 PM	#1
chozobody Join Date: Mar 2013 Location: Hastings, NE Posts: 17 Trader Rating: (0) Feedback Score: 0 reviews	S13 Exhaust Removal I'm in the process of removing the exhaust from my S13. The previous owner replaced the stock exhaust with some no name headers and a straight pipe. (Middle of Nebraska, what do you expect?) I have all the header bolts removed, and I have all but one of the rubber bushings removed from the rear. I have two spots that I can't figure out though. One spot is a solid metal s-shaped hose, and the other is a slightly bigger, L-shaped hose that looks screwed into the header. I need this out fairly soon so I can put my new motor in. Any advice would be greatly appreciated. 240 - Imgur

03-31-2013, 08:28 PM	#3
codyace Post Whore! Join Date: Dec 2004 Location: Poconos, PA Age: 36 Posts: 8,030 Trader Rating: (58) Feedback Score: 58 reviews	I'm unsure what the lower hose is, but the upper threaded one is your EGR tube. Unless your state requires emissions it's easier to cut the egr pipe and remove the system off the car (also putting a cap on the EGR valve) and then remove it on the bench (if it even comes out). You can attempt at soaking it in penetrate, but it may be nearly impossible without heat and penetrating oil. __________________ *Want Air Conditioning in your SR20 Swapped car? Check out www.sr20acbrackets.com for more information! Quest Alternator Conversions for SR20!* Check my Group Buy! Tired of lousy internal gates? Go external wastegate with one of my manifolds, Check out my group buy

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-31-2013, 08:03 PM	#2
foreverdeath Zilvia Junkie Join Date: Sep 2012 Location: va beach Age: 28 Posts: 318 Trader Rating: (3) Feedback Score: 3 reviews	he s hose is for PAIR, and the u shaped pipe is the egr tube. never that joy to trying to remove these. easyest way i assume would be using a large pipe wrench of vise grips, if you want to keep your emissions.