weirdchris555

Hey everyone. I was wiring up my consult last night and ran into an issue on my redtop sr20det. The car was fine before this. I have nistune but everything has been working fine prior to this. I ran the wires over from the consult port to the ecu and left them there. I havnt tied into the ecu wires yet. Well I go to start the car and it runs fine. Then after a couple minutes of running it kicks into limp mode. I checked the code on the led on the ecu, but its constantly on. I have no idea where to begin. It happens after reseting the ecu too. I waited all night and it ran fine for a couple of minutes, but if I try to reset it by pulling the battery for a couple of minutes, it starts right up into limp mode. Please help me. Thanks