View Full Version : Removing the center air vent in an S13
240silvia
01-24-2006, 12:40 PM
Searched, didn't find anything. Does anyone know how to properly remove the center vent, without breaking it? Thanks, Charles.
RyanA96
01-24-2006, 01:01 PM
pull really hard. Or pry it with something but be careful you don't break it.
g6civcx
01-24-2006, 01:26 PM
That's it. Just be extremely careful. Or if you're going to remove the dash any time soon just wait until you do. Then you have more room to work around the back to pop it out.
hellion240sx
01-24-2006, 01:33 PM
yeah i tried to pull it out and cracked it. so b very careful!!!!
Pulling the dash makes it much easier and will make sure that you dont break while removing the piece.
240silvia
01-24-2006, 03:02 PM
How is it being held in there? Anyone know? Tabs?
projectRDM
01-24-2006, 03:04 PM
Tabs, two on top and two on bottom.
yeah i tried to pull it out and cracked it. so b very careful!!!!
irony... i pull it out cause i install a screen there for the dvd player and dont care if break or not... it dont broke, is on the backyard somewhere haha
Irukandji
01-24-2006, 07:04 PM
ahhh i remember this... from what I remember , back when I was swapping interior brown to black on my old 240, I lifted the dash up until i could reach behind and push it out. There were tabs on the top and bottom, just push them towards eachother and push out carefully. They will break easily so be careful. If you don't want to lift the dash, get two thin flat head screw drivers, put one on the top and bottom, slowly push them in between the dash and vent, and push towards eachother. This should release the little brackets. Repeat for the other side.
Hope that helps...
SochBAT
01-24-2006, 09:17 PM
Pull out the dash. Bing bang boom.
Push out vent. Bing bang boom.
Done. Bing bang boom.
240silvia
01-24-2006, 09:18 PM
Thanks for the advice guys, I guess I'll see what happens when I try to take it out.
NemeGuero
01-24-2006, 09:26 PM
Pull out the dash. Bing bang boom.
Push out vent. Bing bang boom.
Done. Bing bang boom.
That's a lot of bing bang booming for something as simple as pulling out a clipped in plastic piece!
krazyskata13
01-24-2006, 11:15 PM
i just did it today.. took me like 5 minutes.. if your talking about the vent about the climate controlls.. there was 1 10mm bolt and it poped right out. good luck
c240sx13
01-24-2006, 11:29 PM
lol oh shit front vents, yeah youll need to take the dash off, sorry
2iv0 sx
01-24-2006, 11:54 PM
I always wondered that same.. everything i would go to the junkyard i would practice on how to take them out, breaking every single one :werd: .. figured its way easier just taking the dash apart and BE PATIENT
240silvia
01-25-2006, 03:50 PM
taking off the dash sure is a lot of work for a little vent. I'm probably going to break it, lol. I guess we'll see what happens. If anyone else has any ideas, let me know.
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.